Does OBD1 to OBD2 adapter work?
Typically obd2 scanners can not read obd 1 data, even with an adapter cable. If your looking to just pull codes then jumpering terminals A and B at the ALDL connector under the dash and counting the check engine light flashes is the most reliable way to get codes from and obd1 gm.
Can you use an OBD2 Scanner on an OBD1 car?
Actron CP9690 diagnostic scanner comes with OBD1 as well as OBD2 cables. As a result, you will be able to perform both basic and most of the advanced functions on both OBD1 and OBD2 vehicles. You will be able to read and clear the check engine light using this diagnostic scanner.
Does Subaru support OBD2?
Subaru vehicles are supported for enhanced diagnostics, too, so you can check non-OBD2 systems like the airbags and anti-lock brakes.
What is the difference between OBD2 and OBD1?
OBD1 is connected to the console of a car, while OBD2 is remotely connected to the vehicle. 2. OBD1 was used during the earlier years of the car manufacturing industry, while OBD2 was only introduced in car models produced in the early 1990’s.
Which is better OBD1 or OBD2?
OBD2 is remotely used to diagnose ports, and reads data through a Bluetooth connection. As such, it is easier to diagnose a problem remotely if you have a car made with an OBD2 system. OBD1 has good diagnostic capabilities, while OBD2 has better signalling protocols and messaging formats.
What OBD2 protocol does Subaru use?
| Protocol | Mode 1 | Mode 9 |
|---|---|---|
| ISO 9141 | BE3FA811 10000000 | 00000000 |
Does BlueDriver work on Subaru?
Almost all of these bluetooth OBD2 devices will work in any modern Subaru BUT you need compatible software. Compatible means both with the device you plan to use (iPhone or Android) and with the device itself. I looked at BlueDriver also but it has its own proprietary software as best I can tell.
How do I get the code for my Ford OBD1?
Insert a test light into the test connector to observe when the key is turned on, also attach a jumper wire from the connector to the signal connector along side of the OBD1 port. Turn the key to the on position. This will initiate the code gathering sequence which be produced in the form of two digits.