Does a carb have to sit level?
The fuel bowl level on a carburetor (and this will vary among models) is extremely important for proper operation, fuel economy, performance and emmissions. If a carb pad tilts forward, the carb will run rich. If tilting backwards, the secondairies will run rich.
Can a carburetor be at an angle?
The angle isn’t too critical. It can slant forward or rearward slightly and even from side to side, slightly. It is a float operatated carb so you must keep float level in mind.
What kind of intake manifolds do GM engines use?
Chevrolet Performance intake manifolds were designed specifically for GM engines, so you know they will deliver OE performance. Dual-pattern carburetor flange is approximately 1/2″ lower than the 1970 LT1 intake, yet produces the same horsepower NOTE: Open carburetor spacer is not recommended for use with dual-plane intake manifolds.
What should the choke be set at on a carburetor?
Adjust the choke such that the choke plate just touches closed at 68 degrees F. (65~70 degrees is close enough). Tighten the retaining screws. For the divorced choke, the same setting applies, but bend the operating rod to set the choke plate.
Why is the Stromberg 97 carb signal unstable?
The signal was unstable at most of the test CFM’s, and taking the average signal at each CFM to figure the signal curve showed a much less manageable curve than with the choke parts installed.
What should I do if my carburetor is not working?
Start the engine, and warm to normal operating temperature. Shut off the engine. Remove the air cleaner. The choke butterfly should be fully open, as the engine is warm. Observe the pump jet in the carburetor, and with your hand, work the carburetor throttle to the wide-open position. You should observe a healthy squirt of fuel from the pump jet.
What are the case numbers for a GMC manual transmission?
Case casting is number 13-53. All aluminum top-loaded transmission with shifter on top of the extension housing with internal single-rail shift linkage. Front and rear main bearings are tapered. The cluster gear is solid and is supported on each end by cylindrical roller bearings located in the case. Case castings numbers are 13-51 or 13-52.
How to identify Chevrolet GMC manual transmissions [ video ]?
After locating correct unit a link is supplied to provide detailed information on specific kit and parts that are available for your unit. Information is provided for General Motors 3 speed, 4 speed , 5 speed and 6 speeds manual transmissions. Cast iron case and extension housing with 4-bolt side cover.
Where is the reverse shift lever located on a GMC?
Cases, extension housings and side covers may be cast iron or aluminum and in any combination thereof. Casting number T10-XX or 13-04 are on passenger side of case. They all have 9-bolt side covers and 36 tooth synchro rings. Reverse shift lever is located in the extension housing, along with main shaft reverse which is a straight cut gear.
Where is the 5th gear on a GMC?
Casting numbers on the case, cover or extension housing are 13-51 or 13-52. 5th gear (overdrive) is located at the rear of the transmission in the extension housing. The cluster gear is supported on both ends by cylindrical roller bearings.