Does a 1996 Jeep Cherokee have airbags?
The 95-96 uses a mechanical driver side airbag.
How to disable an airbag on a Jeep Grand Cherokee?
Disabling the airbag on a Jeep Grand Cherokee takes just a few minutes. The airbag that is attached to the steering wheel cover connects to the fuse box with a couple of electrical wires running through the steering wheel. You can access these wires from underneath the steering wheel when you remove the steering wheel column cover.
How to disable the airbag system in 6 steps?
Immobilize the Passenger Airbag Disabling airbag from the passenger seat is as important as from the front seats. For that, you have to find the yellow wire. At the same time, unfasten the harnessed by pushing the green locking pin. Now you have disabled the passenger seat airbags successfully. 5. Remove the Steering Wheel’s Lower Panel
Where is the fuse on a Jeep Grand Cherokee airbag?
Find the airbag fuse by looking at the diagram on the fuse box lid to see which fuse operates the airbag. Remove the airbag fuse with a fuse puller and find the plastic steering column cover underneath the steering column. Unfasten the screws holding the steering column cover on with a screwdriver and set the cover out of the way.
Why does the airbag light stay on in a jeep?
If all parts of this system are not working properly, it can cause the airbag light to come on. If you’ve been in an accident, the airbag light is going to stay on until the system has been restored. It will not work until repaired. Here are some common reasons that your Grand Cherokee’s airbag light could come on. 1. Seat Belts
Disabling the airbag on a Jeep Grand Cherokee takes just a few minutes. The airbag that is attached to the steering wheel cover connects to the fuse box with a couple of electrical wires running through the steering wheel. You can access these wires from underneath the steering wheel when you remove the steering wheel column cover.
If all parts of this system are not working properly, it can cause the airbag light to come on. If you’ve been in an accident, the airbag light is going to stay on until the system has been restored. It will not work until repaired. Here are some common reasons that your Grand Cherokee’s airbag light could come on. 1. Seat Belts
Find the airbag fuse by looking at the diagram on the fuse box lid to see which fuse operates the airbag. Remove the airbag fuse with a fuse puller and find the plastic steering column cover underneath the steering column. Unfasten the screws holding the steering column cover on with a screwdriver and set the cover out of the way.
Is there a way to deactivate the passenger airbag?
But the passenger airbag can be deactivated if the car is equipped with a Passenger Airbag Cut Off Switch (PACOS). In most cases, to disable the airbag you need to have the ignition switched off to avoid any possible malfunctions. Source: YouTube. The PACOS is usually located in the passenger side of the dash board.