Do you need a trailer brake controller for a Chevy Silverado?
Unfortunately, GM chose not to make trailer brake controllers standard with the HD towing option. For those of you who have a trailer with electronic brakes, this means you’ll need to install one yourself.
Do you need a trailer brake controller for HD towing?
Unfortunately, GM chose not to make trailer brake controllers standard with the HD towing option. For those of you who have a trailer with electronic brakes, this means you’ll need to install one yourself. Luckily, aftermarket trailer brake controllers are relatively inexpensive and definitely worth it for peace of mind when towing heavy loads.
Where is the integrated Trailer Brake Control System?
The vehicle may have an Integrated Trailer Brake Control (ITBC) system for electric trailer brakes. This symbol is located on the Trailer Brake Control Panel on vehicles with an Integrated Trailer Brake Control system.
How to add a brake controller to a GM Truck?
Then a inner cover tracing the inner part of the switch case, then gluing them to together using E6000 Glue. Y ou have to grind down the front of the original switch front to allow it to clip in place with the new (PC Case) front cover. Mounted the control head on the new cover (you have to center and drill hose).
Where is the trailer brake controller on a Silverado?
Looking under the driver side dash on the left side, you’ll see a wiring harness taped up out of the way. This is the trailer brake harness that you’ll need to pull down. Figure 1. Trailer brake controller harness. Once you have the trailer brake wiring to your trailer brake controller wiring mapped out, you can start making the connections.
Unfortunately, GM chose not to make trailer brake controllers standard with the HD towing option. For those of you who have a trailer with electronic brakes, this means you’ll need to install one yourself. Luckily, aftermarket trailer brake controllers are relatively inexpensive and definitely worth it for peace of mind when towing heavy loads.
How much does it cost to install a trailer brake controller?
GM recommends going with an aftermarket controller versus the one that was available from the factory due to the ease of install, and this is good since the factory part will run you around $500. Once you have chosen a trailer brake controller that you like, you’ll need to obtain the wiring schematic for it.
How do you install a splice in brake controller?
Start your splice-in brake controller installation by disconnecting the negative battery cable. This will help ensure your safety while working on the wiring system. It will also help protect your vehicle’s electrical components from damage. Disconnect the negative cable, and move it to the side.