Do Town and Country vans have transmission problems?
Chrysler Town & Country owners have reported 59 problems related to transmission failure (under the power train category).
Are there any recalls on a 2010 Chrysler Town and Country?
There have been 5 safety recalls issued from NHTSA. Summary: Chrysler (FCA US LLC) is recalling certain 2008-2010 Chrysler Town and Country and Dodge Grand Caravan and 2007-2011 Dodge Nitro vehicles. The recall is expected to begin August 26, 2020. Owners may contact FCA US LLC customer service at 1-800-853-1403.
How much does it cost to replace a transmission in a Chrysler Town and Country?
Chrysler Town and Country Transmission Cost The cost of a new Chrysler Town and Country transmission could be over $3,500 depending on the vehicle, however, transmission services such as fluid changes and a transmission fluid flush are considerably less expensive, in some cases costing less than $150.
How much does it cost to repair a transmission?
Average transmission repair costs range from $300 to $1,400. For example, if your manual transmission needs a new clutch, you can reasonably expect to pay around $800 to $1,500. On the other hand, transmission replacement is one of the most expensive repairs you can get. Replacements can range from $1,800 to $3,400.
How do you clear the codes on a Chrysler?
Use a diagnostic scanner to clear the codes. Connect the scanner to the test port, also called the ALDL (Assembly Line Diagnostic Link) usually located under the dash (see Resources section). Turn the engine “On” and follow the prompts on the scanner to pull the engine codes. Select the option to clear them.
What does engine code P1684 mean?
The fault code P1684 means that power to your powertrain control module (PCM) was interrupted. The most common cause of this is because of a weak battery. It can also be caused by a wiring issue to the PCM, or a bad connection in the battery cable.
Is a 2010 Chrysler Town and Country AWD?
The Touring model has a 197-hp 3.8-liter V6 and a six-speed automatic transmission. Standard on the Limited, and optionally available on the Touring, is a 251-hp 4.0-liter V6 with the six-speed automatic. All have front-wheel drive.
How much does it cost to fix a Chrysler 300 transmission?
Chrysler Transmission Replacement Cost The average transmission replacement cost for a Chrysler varies between $1,800 and $3,400.
What was the transmission code on the Chrysler Town and Country?
After rebuild transmission had hard shifting went into limp mode again after 3 days from shop, again while on express way. Codes p0792, p0732, p0735, p0721.
Are there any problems with the Chrysler Town and Country?
The transmission failure is a known issue but no recall issued from Chrysler. Stuck with a $3,338. 92 bill for a new transmission. See all problems of the 2011 Chrysler Town & Country .
What does p0740 mean on a Chrysler Town and Country?
P0740 is one of the most common transmission trouble codes. It means that the Town and Country ‘s computer has detected that there is an issue with the torque converter clutch (TCC) solenoid circuit. The TCC “locks” the drivetrain, which allows for a true mechanical connection between the transmission and the engine.
Why is my torque converter not working on my Chrysler Town and Country?
It means that the Town and Country ‘s computer has detected that there is an issue with the torque converter clutch (TCC) solenoid circuit. The TCC “locks” the drivetrain, which allows for a true mechanical connection between the transmission and the engine.