Do Jeep Wranglers have independent front suspension?
This Front Axle Disconnect (FAD) is new to the JL Wrangler. The JK never had one. The Toyota 4Runner and Tacoma has had something similar for years, but their Automatic Disconnecting Differential (ADD) system is built into the differential housing because they have independent front suspension.
Where is the jack on a 2001 Jeep Wrangler?
The jack handle is in a vinyl bag which is held down by a pair of velcro straps next to the passenger-side seat below the door opening.
Do any Jeeps have independent suspension?
Rego 4×4 makes the REX, a four-wheel-independent suspension system. Every once in a while we see one of these. A company decides to produce an independent front suspension or a full four-wheel-independent suspension system for the Jeep Wrangler JK.
Where is etc indicator located on Jeep Wrangler?
The ETC indicator is controlled by a transistor on the instrument cluster circuit board based upon cluster programming and electronic messages received by the cluster from the Powertrain Control Module (PCM) over the Controller Area Network (CAN) data bus.
What is the bulb test on a Jeep Wrangler?
The entire bulb test is a function of the instrument cluster. ETC Indicator Lamp-On Message- Each time the cluster receives an electronic ETC indicator lamp-ONmessage from the PCM, the ETC indicator will be illuminated.
When does the led go off on a Jeep Wrangler?
Therefore, the LED will always be OFF when the ignition switch is in any position except ON or START. The LED only illuminates when it is provided a path to ground by the instrument cluster transistor. The instrument cluster will turn ON the ETC indicator for the following reasons:
What does a lamp on message mean on a Jeep Wrangler?
If the PCM sends a lamp-ON message after the bulb test, it indicates that the PCM has detected an ETC system malfunction or that the ETC system is ineffective. The PCM will store a Diagnostic Trouble Code (DTC) for any malfunction it detects.
Can a Jeep Wrangler have truetrac in the front axle?
Enter your ride HERE to be a part of JUNE’s Ride of the Month Challenge! I am in the process of regearing to 4.88’s. Installed an ARB locker and chromoly shafts in the rear. Starting the front axle ring and pinion this weekend. The budget does not allow an ARB and stronger shafts for Dana 30.
What kind of lift does a Jeep Wrangler use?
TJ and JK Wrangler lift kits use taller coil springs to increase the distance between the frame and the axles. Larger lifts may include new control arms to maintain suspension alignment providing smoother highway driving.
What kind of suspension does a YJ Wrangler use?
YJ Wranglers do not use control arms thanks to the use of leaf springs which are able to hold the axles in place while acting as springs. TJ, JK, JL Wranglers: In 1997, the Wrangler’s suspension changed over to a 4-wheel coil type suspension which remains the stock suspension setup in Wranglers today.
What kind of Bumper does a Jeep Wrangler have?
Our rear bumpers are made from the same tough steel and offer space for water storage and D-ring brackets. Each bumper is also made to your Wrangler’s specific modifications. They are designed to maximize approach and departure angles without getting your Jeep stuck in a tight spot.