Can you take the doors off a Jeep Cherokee?
It is completely legal to remove your Jeep doors and drive on public roads without them, as long as you are sure to take care of a few minor things first. When you remove your Jeep doors, you will also be removing the mirrors. In order to remain in compliance with state laws, you must re-attach your mirrors.
How do you remove a door from a Jeep Cherokee?
Pull the electrical through. Disconnect the door retainer that holds the door open either by hammering the pin upwards, by unbolting it, or by cutting it off. Unbolt the door from the hinges or in the older Jeep Cherokee’s case, cut the hinges with a sawzall.
How to diagnose and replace Jeep Grand Cherokee blend doors?
This video shows you how to Diagnose and Replace the Blend Doors in a 1999-2004 Jeep Grand Cherokee. Make sure that your specify if your vehicle has two heat zones or just one. New part we installed is designed for one heat zone. This is why it was not necessary to reinstall the blend door partition.
What’s the best way to remove a door panel?
If you need more information on how to do that check out the Door Panel Removal Video. Pull or cut out the glued door seal to allow access inside the door. On a manual window use the crank to roll down the window halfway to give you access to the bolt that holds the window to the regulator.
How do you remove window glass on a Jeep Cherokee?
On a manual window use the crank to roll down the window halfway to give you access to the bolt that holds the window to the regulator. If it’s an electric window, use a battery from a cordless drill to jump the window motor till the bolt is showing.
Pull the electrical through. Disconnect the door retainer that holds the door open either by hammering the pin upwards, by unbolting it, or by cutting it off. Unbolt the door from the hinges or in the older Jeep Cherokee’s case, cut the hinges with a sawzall.
On a manual window use the crank to roll down the window halfway to give you access to the bolt that holds the window to the regulator. If it’s an electric window, use a battery from a cordless drill to jump the window motor till the bolt is showing.
If you need more information on how to do that check out the Door Panel Removal Video. Pull or cut out the glued door seal to allow access inside the door. On a manual window use the crank to roll down the window halfway to give you access to the bolt that holds the window to the regulator.