Can you replace the ignition switch on a 1996 Chevy S10?
The ignition switch on your 1996 Chevrolet S-10 can get a lot of use, particularly if the vehicle has logged a lot of miles. When it malfunctions, you won’t be able to start the vehicle. Fortunately, replacing the ignition switch with a new one isn’t a very difficult process, and can be done in approximately an hour with some basic tools.
What’s the best way to remove an ignition switch?
Remove them carefully by either popping them off of their plastic clips or removing the screws and bolts that hold those pieces in place. Refer to a vehicle specific repair manual for guidance on how best to gain access to the ignition switch. Set all trim pieces aside somewhere safe where they won’t get stepped on or damaged. Helpful?
Where is the cover on the ignition switch?
On most vehicles, there is a plastic or metal cover on the ignition lock cylinder. Remove the small screw that holds this cover on, typically located on the bottom of the switch. Once the screw has been removed, carefully slide the cover off the ignition lock cylinder.
What to do if your key is stuck in the ignition switch?
The key may be stuck in the ignition switch, but that shouldn’t stop you from turning it. If you don’t have a key, you will need to force the module to turn using a flathead screwdriver. Press the release pin inside the hole on the ignition module with a screwdriver.
How to change the ignition switch on an S-10 pickup?
Disconnect the negative battery cable from the battery by using an 8-mm wrench to remove the battery terminal bolt. Remove the lower trim and sound deadener located below the driver’s side of the dash using Phillips screwdriver for the screws and a socket and ratchet for the remaining 7-mm bolts. Lay the two panels aside in the passenger seat.
Why are my ignition switches not working on my Chevy S10?
If the connectors are blocked by the grime and grit that have built up over years of hard use, you’re apt to experience a truck that simply refuses to work. AutoZone offers assistance to those looking to replace their S-10 ignition switches by providing free advice via their professional, trustworthy staff.
What should I do if I need to replace my ignition switch?
Reconnect the cable to the negative (-) terminal on the battery, then insert the key into the ignition and turn it to start the vehicle. The vehicle should start without any issue. If it doesn’t, remove the ignition switch and reinstall it. Shut the engine off (if it starts) and disconnect the battery again.
How do you remove a battery from an ignition switch?
Use an appropriate sized wrench to loosen the nut holding the cable on the negative (-) terminal and then slide it off the post. You don’t need to remove the positive cable from its terminal. Tuck the negative cable to the side of the battery to make sure it doesn’t accidentally come into contact with the terminals.