Can you put regular gas in a RX8?
Because drivers have to keep the engine in the high rev range for maximum power, Automobile.com says that “the obvious penalty hit my wallet when the time arrived to top up the go-go juice.” AutoWeek describes the RX-8 as having an “unquenchable thirst” that’s “not-so-earth-friendly.” The RX-8 requires Premium Unleaded …
What kind of gas does a rotary engine take?
For a turbocharged rotary, Prather recommends 91-octane fuel or higher. “For turbo use,” he adds, “it’s imperative to be aware of your timing and keep that lower for use with boost.” “Racing fuels in general are more refined than pump gas and will tend to burn cleaner, with less soot residue.”
Why does my Mazda RX-8 engine not start?
At the time it sounded like the battery, because engine turned very slowly. Since, I’ve changed battery, checked all fuses, and engine still doesn’t start (though it engine turns fine). Would you please assist me with any info which will help me to determine what’s wrong.
What kind of gas does a RX-8 rotary engine use?
The RX-8 has a Wankel rotary engine. This engine (and especially the tip seals) may respond to lower octane gas differently. If this were my car I’d feed it 91 octane or sell it. When the owner’s manual says “91 is recommended,” that’s one thing, but when it says “91 is REQUIRED,” you should do what the manual says.
Which is better Mazda crossfire or Mazda RX 8?
While the RX-8 is one of the purest sports cars on the road, the Crossfire is more of a GT car. Although it’s undeniably a fine car, I don’t think the Crossfire really compares to the RX-8 from a sporting point of view – plus, it doesn’t have a back seat.
What should I do if my Mazda RX-8 stall?
Try puting your car in neutral at the light – the vibration should stop or be barely noticeable. Mazda had a regional rep come out to look at my car, and his solution was to give me my 7th set of motor mounts. The vibration was a little better for about 10 feet, then it was back and worse than ever.
What kind of engine can I put in a Mazda RX-8?
There’s actually a lot of interest for a 6-cylinder powered Mazda RX-8. Narrow angle V6s can be installed and tucked away neatly within the RX-8’s motor compartment. Perhaps most intriguing, is the LFX swap, a 3.5-litre 54-degree V6 found in many Cadillacs.
At the time it sounded like the battery, because engine turned very slowly. Since, I’ve changed battery, checked all fuses, and engine still doesn’t start (though it engine turns fine). Would you please assist me with any info which will help me to determine what’s wrong.
When to check oil level in Mazda RX-8?
The amount of oil used depends upon how hard the engine is driven. Driving the car without enough oil can severely damage the engine. Mazda recommends checking the oil at every second fuel fill. Before inspecting the oil level, warm up the engine to normal operating temperature. Stop the engine and allow the oil to settle for a minute.
What’s the best way to stop a Mazda RX 8?
Stopping Procedure Should your Mazda RX-8 not reach normal operating temperature before the end of your journey, please use the following stopping procedure: With the engine running and transmission in neutral, increase engine revs to 4,000 rpm. Hold revs at 4,000 rpm for 10 seconds. Turn off the ignition while the engine is running at 4,000 rpm.