Can you change the position of a belt pulley?
This will require you to change the mounting position as you take the measurements. If you feel that there is not enough room between the radiator and the straight edge to take measurements remove the fan spacer and mount the straight edge to the front of the pulley with shorter bolts.
What kind of pulleys are in a Chevy C20 350?
The fallowing was used GM 350 crate engine, aftermarket high flow short style water pump, aftermarket harmonic balancer, aftermarket alternator 100 amp internal regulator, rebuilt power steering pump and all pulleys & mounting brackets from a 72 Chevy C10 350 engine.
When to take shims out of belt pulleys?
After shimming the primary mount you will need to look at the secondary/support mountings to see if they need shimming or modification. After all shimming is complete and you have re-checked your alignment recommend pulling all the shims out and painting them to prevent corrosion.
Can a power steering pump pulley be moved forward?
Now, on to the power steering pump pulley alignment to the crankshaft pulley. The power steering pump can not be moved aft with shimming. Normally if shimming is required, it will be forward. I also have an additional problem with the power steering pump pulley.
What’s the best way to replace a tensioner pulley?
So, be careful using a wire brush. You can always spray paint them. Tensioner Pulley Bearing – This is the easiest bearing to replace because the bearing is readily available – the size is 17X40X17.5 (ID X OD X Width).
Can you replace the bearings in a Toyota idler pulley?
Unfortunately, Toyota does not sell replacement bearings; you have to buy the pulley with an installed bearing, or for the tensioner, you are forced to purchase the entire assembly. On top of that Toyota uses proprietary sized bearings in the idler pulleys.
Can you replace the pulley on a Sienna?
Of course, you could always buy the whole tensioner and only replace the pulley/bearing (and the bolt). You wouldn’t save any money on the part, but you’d know it was the right pulley/bearing. As for the Sienna, it’s been pretty reliable. We bought it eleven years go with 83,000 miles, and it now has 195,000.
Can you replace the pulleys on a Ford F-150?
Swapping out those noisy pulleys and belts its actually a pretty simple task that doesn’t require any special tools or skill. Put and end to the whining in your F-150 or F-250’s front-end below. A bad pulley can be very annoying and with quite a few on your motor, hard to diagnose.