Can you change the engine of a Mazda 6?
With just a few mods you can change your Mazda 6 into a really fun car, potentially beating larger cars on the track. Sadly with smaller engine sizes you are wasting your time spending money on modifications, so if this applies to you get yourself an engine swap then apply the following mods.
What kind of tuning do I need for a Mazda 6?
Engine tuning mods. Anything less than the 2.0 NASP is a bit of a waste of time when it comes to tuning as the cost is quite high and the return in power is relatively low. You might look to the other Mazda engine options to source a suitable donor and do a 2.3 Turbo conversion from the 3 range.
Is the Mazda 6 a good car to buy?
The Mazda 6 is a good attack on producing an executive car. The car is well thought out and has a good range of engine options and a good chassis design. However the 6 was not originally aimed a the performance market until in very recent times, and as a result they lack many of the interesting engine options available in other marques.
Can You tune a Mazda MZR L engine?
Mazda MZR L are popular tuning projects and with the right sports parts like a remap, turbo kits and camshafts you will noticeably maximise your driving opportunities. This engine was used extensively by Ford and appeared in the Volvo line up under different guises, and we get asked quite a bit about improving, tuning and uprating it.
How to increase engine speed in Mazda 6?
1. Make sure the engine is warmed up (important). 2. Start the engine. 3. Connect the pin in the red circle to earth (chassis). 4. Press the accelerator to the floor and release 2 times. 5. The engine speed increases, if not got to (2).
How to start DPF cleaning process in Mazda 6?
How to start DPF cleaning process VERY IMPORTANT: Do only this outdoors with 5m free behind the exhaust and with the hood open. 1. Make sure the engine is warmed up (important). 2. Start the engine. 3. Connect the pin in the red circle to earth (chassis). 4. Press the accelerator to the floor and release 2 times. 5.
How to get the Mazda 6 cardiagnostics right?
1. Make sure the engine is warmed up (important). 2. Start the engine. 3. Connect the pin in the red circle 5 times within 5 sec. to earth (chassis). 4. The glow plug light flashes 5 times when the calibration is finish (< 3 min). 5. If not got to (2). The injector calibration can be a bit tricky to get right the first time so don’t panic
How to change the glow plug on a Mazda 6?
1. Change oil and oil filter. 2. Reset for oil change. 3. Warm up the car, take it for a drive. 4. Clean the DPF. takes about half an hour. 5. Calibrate the injectors. 6. Finish. ** I have not seen the glow plug flash 5 times but I wait until it goes to idle after about 4 min.