Can a Nissan Murano have a no good battery?
A no good battery after 2 years and 31,548 miles, umm, seems strange. I just bought a 2003 Nissan Murano, recently I have had a few problems with the car. First problem, after driving about 30 miles and then shutting the engine off and then turning on the alarm.
Are there any problems with the 2011 Nissan Murano?
See all problems of the 2011 Nissan Murano . Car will not start and does not turn over. Tried battery, different fob, new fob batteries, rolling vehicle, tries starting in neutral, etc. No results. Feels like steering wheel is not in locked position. See all problems of the 2009 Nissan Murano .
When to use no crank, no start?
Whenever you have a no start condition when attempting to start your vehicle it’s important to make the distinction between “no crank, no start” and “crank, no start” situations as they are treated differently.
Where can I get a Nissan Murano serviced?
On the outside of the vehicle, there was a burning odor. The vehicle was taken to price leblanc Nissan (14295 airline hwy, gonzales, la 70737, (225) 743-8100) where it was diagnosed that the abs motor failed and needed to be replaced. The vehicle was not repaired. The VIN was included in NHTSA campaign number: 16v636000 (service brakes, hydraulic).
What are common reasons my Nissan Murano won’t start?
What are common reasons my Nissan Murano won’t start? While there are a variety of reasons your Nissan Murano won’t start, the most common 3 are a dead battery, an alternator problem, or failed starter. How is a no-start diagnosis fixed?
What does OBDII code p0013 mean on Murano?
There will usually be OBDII codes associated with timing related problems, but not always. P0013 is a common camshaft position related code. The crankshaft sensor can go bad as well. When these sensors go bad, it can be impossible for your Murano to start.
Why does my Murano not transfer power to rear wheels?
If your Murano is too low on transmission fluid, it’ll will no longer be able to transfer power to the rear wheels. The power goes to the torque converter, and that’s the end of the line. You should check the transmission fluid immediately.
A no good battery after 2 years and 31,548 miles, umm, seems strange. I just bought a 2003 Nissan Murano, recently I have had a few problems with the car. First problem, after driving about 30 miles and then shutting the engine off and then turning on the alarm.
See all problems of the 2011 Nissan Murano . Car will not start and does not turn over. Tried battery, different fob, new fob batteries, rolling vehicle, tries starting in neutral, etc. No results. Feels like steering wheel is not in locked position. See all problems of the 2009 Nissan Murano .
Why does my car not start after I drain the battery?
A broken timing belt, timing chain or timing gear means you can crank the engine until you drain the battery, and it still won’t start. Likewise, a bad crankshaft position sensor won’t send the right signals to the engine computer to allow the engine to start. 8. Smart Key Issue
On the outside of the vehicle, there was a burning odor. The vehicle was taken to price leblanc Nissan (14295 airline hwy, gonzales, la 70737, (225) 743-8100) where it was diagnosed that the abs motor failed and needed to be replaced. The vehicle was not repaired. The VIN was included in NHTSA campaign number: 16v636000 (service brakes, hydraulic).
What should I do if I have a Nissan p1610 code?
If the problem persists you have to have the dealer erase the code and reprogram the keys again. 1. Turn ignition switch OFF. 2. Turn ignition switch ON with registered key. (Do not start engine.) Wait 5 seconds. 3. Return the key to OFF position. 4. Repeat steps 2 and 3 twice (total of three cycles). 5. Start the engine. What does this mean?
What to do if your Nissan Murano wont start?
I drove approx 1/8 mile to the gas station on the opposite side of the street from Nissan, pulled into the gas station, turned off the ignition, gas attendant filled gas tank. . . . Then I turned the key and the car would not start.
Why does my car not start in lock mode?
Both P1610 and P1614 indicate a NATS (anti-theft system) malfunction, yet P1610 is a resulting DTC from the “LOCK MODE” condition which is set for various NATS malfunctions or an improper key being used. It prevents the car from starting (for some period of time, even if the key issue is rectified).
Why does my Nissan Murano not start up?
Found that the issue is related to the brake pedal interlock which shuts down the electrical system. After 64 days at dealership to replace faulty air bags I retrieved my car today.
What to do if Nissan p1610 lock mode?
If the problem occurs try disconnecting the car battery for about 30 minutes and then try starting the engine with a known registered key. If the problem persists you have to have the dealer erase the code and reprogram the keys again. 1. Turn ignition switch OFF. 2. Turn ignition switch ON with registered key. (Do not start engine.)
How much does it cost to fix a Nissan p1610 code?
5. Start the engine. The cost to diagnose the P1610 NISSAN code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
What causes a Nissan Murano to not start?
The most common causes that hinders normal starting operation of your Murano are dead key fob battery, dead 12v battery, corrosion on battery terminals, bad alternator, clogged fuel filter, broken starter, blown fuse, empty gas tank, immobilizer error or any fault in the electrical system. 1. Weak Battery
What should the voltage be on a Nissan Murano?
The voltage of the battery on your Nissan Murano can be measured precisely with a multimeter. Before the test, the multimeter is set to the voltage range of the battery and connected to its plus and minus poles. Successful testing of the car battery, i.e. checking the voltage, usually results in values of approx. 12 to 13 volts.
The most common causes that hinders normal starting operation of your Murano are dead key fob battery, dead 12v battery, corrosion on battery terminals, bad alternator, clogged fuel filter, broken starter, blown fuse, empty gas tank, immobilizer error or any fault in the electrical system. 1. Weak Battery
The voltage of the battery on your Nissan Murano can be measured precisely with a multimeter. Before the test, the multimeter is set to the voltage range of the battery and connected to its plus and minus poles. Successful testing of the car battery, i.e. checking the voltage, usually results in values of approx. 12 to 13 volts.
There will usually be OBDII codes associated with timing related problems, but not always. P0013 is a common camshaft position related code. The crankshaft sensor can go bad as well. When these sensors go bad, it can be impossible for your Murano to start.
What kind of problem does a Nissan Murano have?
Tl the contact owns a 2016 Nissan Murano. The contact stated that the vehicle failed to start and all the warning indicators illuminated. On the outside of the vehicle, there was a burning odor.
What happens if you have a bad alternator on a Murano?
The alternator’s job in your Murano is to provide electricity as it is running. The battery stores enough voltage to be able to start the engine without the assistance of an alternator. It is turned by a serpentine belt. It’s worth noting that a bad serpentine belt can cause the alternator to stop charging effectively.