Can a Mitsubishi SRS airbag module be reset?
Our services are easy to use and will save you hundreds! MyAirbags is proud to offer Mitsubishi SRS Airbag Module Reset and Mitsubishi Seat Belt Pretensioner Repair services to get your Mitsubishi back on the road again safely.
Where is the SRS airbag control module located?
In most GM cars it is under the driver or passenger seat. Disconnect the positive battery cable and wait 3 min. You are now safe to unplug the airbag control module harness wiring plugs. All airbag srs components must be installed and connected properly before installing the airbag control module.
Why does the Mitsubishi SRS warning light stay on?
Mitsubishi airbag warning light stays on to notify the driver that the airbags may not deploy if you get in an accident. Airbag or SRS light stays on when the Supplement Restraint System (SRS) detects a malfunction. If the airbags don’t deploy during an accident, you or your passengers may suffer serious injuries.
When does the SRS airbag warning light come on?
Low voltage – SRS airbag light can be triggered when you jump-start a dead car battery. Previous accident – Even a small accident may be recorded in the SRS module triggering the airbag light to come on.
Can You unplug the SRS airbag control module?
You are now safe to unplug the airbag control module harness wiring plugs. All airbag srs components must be installed and connected properly before installing the airbag control module. This includes air bags, seat belts, clock spring and impact sensors. Disconnect the battery and bolt down the module and then connect the harness wiring plugs.
How to troubleshoot Mitsubishi SRS airbag warning light?
Turn on the ignition and allow the scanner to power on. Select your Mitsubishi model and year. For example, in 2017, Lancer. Select SRS / Airbag Control unit from the main menu. Select Read Fault Codes. Write down all the codes and also make sure they are NOT PRESENT.
How do you install an airbag control module?
All airbag srs components must be installed and connected properly before installing the airbag control module. This includes air bags, seat belts, clock spring and impact sensors. Disconnect the battery and bolt down the module and then connect the harness wiring plugs.
Where is the airbag scanner on a Mitsubishi Lancer?
Plug the Mitsubishi airbag scanner into the OBD2 port under the dashboard, driver’s side. Turn on the ignition and allow the scanner to power on. Select your Mitsubishi model and year. For example, in 2017, Lancer. Select SRS / Airbag Control unit from the main menu. Select Read Fault Codes.