Can a car start with no crank or no starter?
Yes, especially if there is a bad connection to the starter, or from the battery. Doesn’t take much juice to click the solenoid, but it takes a lot of juice to turn the starter and turn over the engine.
What to do if your starter won’t start?
Clean all connections both at the starter and the battery to ensure there is no bad connection. You can often locate bad connections by feeling on the cable connection; it will create a lot of heat if there is a bad connection. You can identify the flywheel as the large wheel that is located between the engine and transmission.
Why does my starter click when I turn the key?
It sounds like power is getting to the starter because I can hear a loud click when I turn the key. I’ve researched the topic thoroughly on this site but no one has seemed to have the same problem. In all the other cases there is click coming from the starter. Any help greatly appreciated. Thanks
Is it possible that the starter could check out fine?
Is it possible that the starter could check out fine on a benchg test but still not work when in the truck? Yes, especially if there is a bad connection to the starter, or from the battery. Doesn’t take much juice to click the solenoid, but it takes a lot of juice to turn the starter and turn over the engine.
What to do if your starter relay wont click?
Now just because the relay doesnt click doesnt mean its the fault. You could try a voltage check at your relay signal voltage. If you have power coming from your start button it should be measurable.
What does no start no crank no click mean?
If you have a late model GM vehicle and turn the key only to hear nothing, you’ll most likely think you have a dead battery—and you may. But a no start, no crank, no click condition can be far more involved than that. In the old days, power flowed through the ignition switch and down to the starter solenoid. Not anymore.
What does it mean when your car starter is not working?
Start your engine and listen carefully to the sounds it is making. If there is a loud click, it means the starter relay is working correctly. A weak click means there is a loose connection. Check the wires that connect to your starter solenoid and tighten them.
Why does my starter light not light up?
The fuse on the OTHER side however will not light up the test light. The black cable that goes from the starter to the relay does NOT light up the light UNLESS i am pressing the start button. When i press the start button, the black cable WILL light up the light.