Can a 5 speed transmission be installed in a Honda Accord?
Even though the 5-speed manual transmission has an extra hole for an extra bolt, it is not necessary to use. Drill three holes through the firewall to install the master clutch cylinder mounting studs and the large center plunger. This will require the use of two nuts to install the cabin side mounting studs, which act as spacer.
How do you change gears on a Honda Accord?
Place the floor jack in position under the transmission to hold it, and then lower it. Place the floor jack under the transmission, and tightly secure it with jack clamps. Use your ratchet and socket to remove the eight bolts holding the torque converter to the flex plate.
Where is the transmission hole on a Honda Accord?
Drill a new hole in the transmission bracket in the location of the small dimple located above and to the left of the automatic transmission hole. This step focuses on option #2 as most do not have access to a MIG welder to follow option #1. Set the manual transmission onto the floor jack, and secure it with jack clamps.
How do you change the automatic on a Honda Accord?
Completely slide the seat back. Remove the plastic boot-cover at the rear foot of the seat. Remove 14mm bolts from the rear brackets. Slide the seat forward. Remove the plastic boot-cover at the front foot of the seat. Remove 14mm bolts from the front brackets. Pull it out, and set aside the front seat. Figure 1.
Can a Honda Accord have an automatic transmission?
This how-to will help you to swap your Honda Accord’s automatic transmission with a 5-speed manual. This article applies to the Honda Accord (1990-2002). So you have a really nice Honda Accord with an automatic transmission, but it reminds you of the family sedan rather than a sports car.
Can a Honda Accord be a 5 speed manual?
If you’ve maxed out your performance mods, try converting your automatic transmission into a five speed manual. This how-to will help you to swap your Honda Accord’s automatic transmission with a 5-speed manual. This article applies to the Honda Accord (1990-2002).
Place the floor jack in position under the transmission to hold it, and then lower it. Place the floor jack under the transmission, and tightly secure it with jack clamps. Use your ratchet and socket to remove the eight bolts holding the torque converter to the flex plate.
Drill a new hole in the transmission bracket in the location of the small dimple located above and to the left of the automatic transmission hole. This step focuses on option #2 as most do not have access to a MIG welder to follow option #1. Set the manual transmission onto the floor jack, and secure it with jack clamps.
Where is the drain plug on a Honda Accord?
With the car in the air, you will want to position the drain pan below the location of the drain plug. The drain plug will be lower than the fill plug and will fit a 3/8″ square ratchet. Turn it clockwise to loosen.
How do you change transmission fluid in a Honda Accord?
Replace drain plug. Open the hood and remove the transmission fluid dipstick. The handle will be yellow and located near the battery. Insert funnel and fill the transmission with three quarts of Honda ATF. Figure 4.