Are there replacement CV joints for Honda ATVs?
Replacement CV Joints are designed as a direct factory OEM part replacement with no modifications necessary. Built to exacting measurements and size of the original components these joints are an equal or… Lightning Cv Boot by NorRec®.
When to replace a CV axle on an ATV?
Replace your worn out, inexpensive CV boots before dirt and grime destroy your expensive CV Joint. A good CV boot seal is critical for CV joint protection and longevity on your ATV. The Tusk CV Boot Banding Tool allows you to easily and properly secure your CV boot bands on your UTV/ATV.
How do you replace a CV axle nut?
First step support the front of the machine off of the ground and remove the wheel. Then remove the axle nut. If you don’t have an impact you might want to remove the center cap from the wheel and break the nut loose before lifting the machine off of the ground. Remove the lower ball joint nut. Remove the nut from the lower shock mounting bolt.
How do you remove the driveshaft from a Honda ATV?
Pull the caps out with the pliers, and when all of the caps are removed, pull the universal joint off of the driveshaft. Slide the driveshaft out from under the ATV and lay it in a clean, open area. Make sure to set the parking brake on the ATV prior to crawling underneath of the vehicle to work on it.
How do you replace a CV axle on a UTV?
the CV boot clamps. Pull the boots away from the CV joint and up the axle. axles are painted or powdercoated. Grasp the joint as shown and smack the CV joint with the dead blow or brass hammer. It will take a bit of force to drive the joint off the axle. Flip the other side. replace the parts that are damaged. Slide the boots onto the
What’s the best way to replace an axle?
Slide the boots onto the axle, and then install the small clip onto the axle end. Be sure to use the proper boots on the correct ends of the axle. You can either hold the axle in the vise and drive the joint onto it, or, if you have a table with a hole in it, you can place the joint securely in it and drive the axle down into the joint.
How many CV shafts does a Yamaha 660 Grizzly have?
All modern ATVs use CV shafts in one form or another, this Yamaha 660 Grizzly has a total of ten! They are easily torn, and if left un checked will ruin the CV joint. They are not hard to replace, as you will see. I created this video and I own all rights to all content in the video.