Are there any problems with the Yamaha WaveRunner ex?
I’m also having this issue with the overheating warning indicator and then the ski goes into limp mode 2018 yamaha waverunner ex
Why does my Yamaha WaveRunner make a sputtering noise?
So I took my Yamaha Waverunner VX 1100 Deluxe out to tackle some big waves and on the way back, it started to make a small sputtering noise and would not go past 35 mph; the sound is faint and muffled, as if something is clogged or not getting through causing it to loose power.
Why does my WaveRunner not go above 35 mph?
If you do the same and stand in front of the cylinders, you may get sprayed in the face with fuel, so make sure you are standing on the other side before testing. This was a nerve racking test because if a cylinder comes back with really low compression, it may indicate that you need some VERY EXPENSIVE work done.
How do you change the fuel in a WaveRunner?
Place the two alligator clamps onto each connect of the fuel injector, plug the AC to DC adapter into the wall. Now, press your button and then press the spray top of the carb cleaner to allow a little cleaner to flow into the injector – you’ll see a spray coming out the bottom.
What to do if your WaveRunner won’t start?
Solution: Another common reason why a WaveRunner won’t crank is a starter motor fault. Replace the starter if needed or take your craft to your dealer. If your WaveRunner turns over but the engine still won’t start here are some things that should be checked:
So I took my Yamaha Waverunner VX 1100 Deluxe out to tackle some big waves and on the way back, it started to make a small sputtering noise and would not go past 35 mph; the sound is faint and muffled, as if something is clogged or not getting through causing it to loose power.
What causes a Wave Runner to loose power?
I passed the picture on to a few experts, did some extensive research on the internet and found a number of suggestions that would cause my Waverunner to loose power, they are: Most batteries don’t play well with waves, check battery voltage. Wear ring which surrounds the impeller letting water through
Place the two alligator clamps onto each connect of the fuel injector, plug the AC to DC adapter into the wall. Now, press your button and then press the spray top of the carb cleaner to allow a little cleaner to flow into the injector – you’ll see a spray coming out the bottom.