Are there any problems with the mule 610?

Are there any problems with the mule 610?

Those are a couple random thoughts on this situation, for what they’re worth. @007 Mule 610. It will start and run for about a minute the dies. It blow 20 amp fuse. I am having this issue right now.

Can a Kawasaki MULE 610 run out of oil?

Don’t worry about the engine unless the governor is disconnected or modified. The engines just don’t fail. Well unless they’re run out of oil, and even then, they’ll run for an hour or so with zero oil in them at full throttle (experience speaking). They don’t make enough power to hurt themselves.

Why does my Kawasaki MULE have no power?

I noticed a few times that the fuse holder was very warm but I don’t believe Kawasaki would have made such a mistake. 5 days ago, after having to tow the mule to my shop, I decided that I was going to find that problem. I started checking power at the battery and moved toward the switch. I found that I had no power at the fuse holder.

Can a solenoid be replaced on a mule 550?

I would say replace the solenoid, they are $30 or so on eBay and easy to install, but I had the same problem on my Mule 550 gas and a new solenoid did not fix the problem. I posted a similar question yesterday, but have not received any replies.

Those are a couple random thoughts on this situation, for what they’re worth. @007 Mule 610. It will start and run for about a minute the dies. It blow 20 amp fuse. I am having this issue right now.

What causes a clutch to not engage fully?

A clutch that doesn’t engage fully, or slips under heavy load, is the normal failure mode of a worn out friction disc of pressure plate that has lost its tension. When you press the clutch, your foot counters the diaphragm spring which presses the friction disc to the flywheel.

Don’t worry about the engine unless the governor is disconnected or modified. The engines just don’t fail. Well unless they’re run out of oil, and even then, they’ll run for an hour or so with zero oil in them at full throttle (experience speaking). They don’t make enough power to hurt themselves.

Why does my Kawasaki MULE run at low speeds?

It’s designed to run full throttle all the time. In the Mules, they commonly get run at lower speeds for short distances and a lot of them sit and idle for extended periods. Both of these conditions cause vapors to build up in the crankcase. Sometimes there’s enough humidity in the air to show up as milky oil.

Why does my Kawasaki MULE 610 not start?

But about 50% of the time when you turn the key, you can hear (and feel) the solenoid moving in the starter motor, but the motor itself fails to turn, so it does not start. And then 5 minutes later you might be able to go back to it and turn the key and it will start right up. Or it won’t start at all.

Why does my mule 610 blow 20 amp fuse?

Intake valve gets a little tight and causes more reversion in the intake tract, which doesn’t help matters any. Those are a couple random thoughts on this situation, for what they’re worth. @007 Mule 610. It will start and run for about a minute the dies. It blow 20 amp fuse.

Why is the dipstick not working on my Mule 610?

Then the crankcase pressure will not vent, and it blows the dipstick out. Then warm up the engine and change your engine oil and filter, so you get all the water that is trapped in the engine and oil out of the system. When it is cold you want fresh oil or the problem will return in short order.

Where is the air intake on a mule 610?

Also-when the 610’s first came out, we were advised that some people would haul them backwards on the trailer. Meaning back it up onto the trailer. If you look at the air intake, it’s at the top of the roll bar in the back side of it.

Then the crankcase pressure will not vent, and it blows the dipstick out. Then warm up the engine and change your engine oil and filter, so you get all the water that is trapped in the engine and oil out of the system. When it is cold you want fresh oil or the problem will return in short order.

What’s the price of a Kawasaki MULE 610?

All models were available in moss green, blue, red, and black and cost between $7,299 and $9,399. Despite being a more compact UTV, several ATV publications and reviews considered this successor inferior to the Kawasaki Mule 610. Engine: The 610 uses a four-stroke, air-cooled single-cylinder OHV engine.

When do Kawasaki mules come out for sale?

You might like these other Kawasaki ATVs. THE MID-SIZE MEMBER OF THE MULE™ FAMILY STRONG MEETS MID-SIZEMid-size 2021 Kawasaki MULE PRO-MX™ side x sides offer a comfortable fit for two pass… 2021 Kawasaki Mule Pro-MX EPS Camo, 0% for 12 mos or 2.95% for 36 mos Expires 6/30/2021 2021 Kawasaki Mule Pro-MX™ EPS Camo STRONG MEETS MID-SIZE M…

Can a Kawasaki MULE fit in a truck?

2021 Kawasaki Mule SX 4×4 XC LE FI, 2021 Kawasaki Mule SX™ 4×4 XC LE FI FITS IN THE BED OF A PICKUP TRUCK Styled in the image of its full-size MULE�… 2021 Kawasaki Mule PRO-MX EPS LE, MULE PRO-MX Mid-size 2021 Kawasaki MULE PRO-MX side x sides offer a comfortable fit for two passengers with…

When does Kawasaki MULE PRO-MX EPs expire?

2021 Kawasaki Mule Pro-MX EPS Camo, 0% for 12 mos or 2.95% for 36 mos Expires 6/30/2021 2021 Kawasaki Mule Pro-MX™ EPS Camo STRONG MEETS MID-SIZE M… 2021 Kawasaki Mule Pro-DXT EPS Diesel FE, 2021 Kawasaki Mule Pro-DXT™ EPS Diesel FE 3- TO 6-PASSENGER CAPABILITY MULE PRO-DXT™ side x sides put do…