Are there any problems with the Jeep kJ?
Discussion in ‘ Introductions ‘ started by Kujtim, Jan 23, 2020 . I hope you are all having a great day. I am a new member in this forum so I apologize if I am not posting my question/problem in the appropriate section. So here is the deal. I have a Jeep Cherokee KJ 2.8 CRD 2005 and I’ve been having consistent problems with my crankshaft.
What happens if I Reset my Jeep ECM?
To finish off this post , here are a couple of things you should keep in mind. Resetting your Jeep ECM will not have any effect on your vehicle’s mileage, Resetting it should not cause any issues between your other module so feel free to this as many time as you want if you’re trying to diagnose a problem with your car. For good measure.
Why does my Jeep Grand Cherokee not start?
The mechanic has checked my glowplugs, which go out on the dashboard after 4 seconds and they are still active as per the mechanics test meter for a further 20 seconds, but it still wont start. If I put the easy start spray in the air filter inlet it fires first time. Whatever can be the problem? Submitted:10 years ago. Category: Jeep Show More
What kind of engine does a Jeep Grand Cherokee have?
I am owner of a jeep grand cherokee 2.7 crd 2001, living in Italy. With warm engine, the idling remain high, around 1550 rpm . Even with shift lever in N position, if I accelerate, the idling goes up …
How to check Jeep Grand Cherokee 2.7 fault codes?
Those devices are very expensive and we made a free program for reading/clearing engine and transmission faults for 2.7 Jeep Grand Cherokee. It works with ELM327 based diagnostic device, you can get it from ebay for 5 EUR. Check at our software page. Jeep Grand Cherokee WJ 2.7 CRD limp modes and MIL illumination. Permanent limp-in mode.
What to do if your Jeep Grand Cherokee has electrical problems?
THE AUTO ELECTRICIAN JUST RESET THE POWER TO THE SWITCH FOR THE ELECTRIC WINDOWS. THIS HAS THEN RESET THE COMPUTER AND IT IS ALL WORKING NOW. CHECK ALL YOUR WIRES TO MAKE SURE YOU DONT HAVE A LOOSES CONNECTION. I have a 2006 Jeep Grand Cherokee that I bought from a dealer. It has about 45000 miles on it. Runs great.
What is the Jeep Grand Cherokee 2.7 CRD limp mode?
Jeep Grand Cherokee WJ 2.7 CRD limp modes and MIL illumination. Permanent limp-in mode. When the TCM determines there is a non-recoverable condition present that will not allow proper transmission operation, it will place the transmission in permanent limp-in mode.
What kind of diagnostic device do I need for Jeep Grand Cherokee?
For TCM faults you’ll need a proper diagnostics device as DRB III or Bosch KTS. Those devices are very expensive and we made a free program for reading/clearing engine and transmission faults for 2.7 Jeep Grand Cherokee. It works with ELM327 based diagnostic device, you can get it from ebay for 5 EUR.
Discussion in ‘ Introductions ‘ started by Kujtim, Jan 23, 2020 . I hope you are all having a great day. I am a new member in this forum so I apologize if I am not posting my question/problem in the appropriate section. So here is the deal. I have a Jeep Cherokee KJ 2.8 CRD 2005 and I’ve been having consistent problems with my crankshaft.
Is the 2002 export 2.5L CRD called a Cherokee?
My 2002 Export 2.5L CRD is also called a Cherokee here in SA. Does the engine run smooth with a new crankshaft installed. Counter Balance shaft installed correctly? The local agents here installed the balance shaft slightly off so I had a very rough engine!
Is the bottom of the CRD a problem?
The bottom end of the CRD is normally not a problem unless pieces from the top get in there. Harmonic balancers have gone bad but I’ve never heard of one breaking the crank. Where are you located seeing as you call it a “Cherokee”?
Why does my Jeep CRD fuel pressure solenoid not work?
Buy Jeep CRD Fuel Pressure Solenoid If other work has just been performed be sure that the #4 injector connector and the fuel pressure solenoid connectors are not swapped. This will cause the fuel pressure solenoid to dump pressure and the engine will not start.