Are there any problems with my 1995 Mazda Miata?
Talk about Miata problems and share solutions with other owners here. My 1995 Miata had only 3900 miles on it when I bought it in ’97. I drive it only about 3000 miles each year and store it over the winter. About 4 years ago the engine developed a hiccup, especially at slow speeds. Also, there’s a strong exhaust smell in the trunk.
How to reset wrench on Mazda MX-5 Miata?
IF THE ABOVE TUTORIAL IS NOT APPLICABLE TO YOUR MAZDA MX-5 Miata MODEL. PLEASE FOLLOW THE INTRUCTION BELOW. Press and hold the TRIP BUTTON with the ignition switched off, then switch it on. Keep pressing the selector for more than 5 seconds.
What happens when the timing belt breaks on a Mazda Miata?
On some cars, if the timing belt breaks while the engine is running, you can cause extensive damage to the engine. Basically, on some cars, when the timing belt breaks, a piston can come into contact with the valves and damage both, the piston (s) and valve (s).
How can you tell if your tensioner is failing in a Mazda Miata?
The most typical indication your tensioner is beginning to fail is a squealing sound. Occasionally, if the bearing “go”, the pully will freeze or lock up and put alot of resistance on your belt (s). You will smell the burning rubber at that point.
Are there any problems with the Mazda Miata?
I going to buy a 94 miata with 88,571k miles on the car. My mechanic said that the only problem with the car is that the oil pan begin to leak and it needs to be change. does anybody know how much will this cost to replace the oil pan or (gasket). and will the insurance be really exspensive because i’m a 17 yrs olds male.
How do I Reset my Mazda MX 5 Miata?
Turn Ignition OFF. Maintenance Reset is complete. IF THE ABOVE TUTORIAL IS NOT APPLICABLE TO YOUR MAZDA MX-5 Miata MODEL. PLEASE FOLLOW THE INTRUCTION BELOW. Press and hold the TRIP BUTTON with the ignition switched off, then switch it on. Keep pressing the selector for more than 5 seconds.
How do you reset the wrench on a Miata?
Press and hold the TRIP BUTTON with the ignition switched off, then switch it on. Keep pressing the selector for more than 5 seconds. The master warning light will flash for a few seconds when the reset is completed. THESE TUTORIAL MAY ALSO WORK TO THE FOLLOWING CAR MODEL.
Why is my turn signal on my Miata not working?
I found a suspicious solder connection on the solenoid that controlled the right side. This connection was one of the larger ones on the board and looked worn or broken. I heated the connection and applied a bit more solder and reinstalled the module.