Will a cj7 windshield fit a YJ?
Registered. The CJ doors will fit but they latch differently than the YJ door. As far as the windshield frame, they are basically the same except for where the hinges mount. you would have to drill new holes in the CJ frame and figure out how to hold the nuts inside.
What size is a Jeep Wrangler windshield?
Wrangler/YJ (’86-1/2 – ’91): Windshield width 55″, round fender Jeep, one piece windshield, factory roll bar with horizontal supports.
Will a Wrangler soft top fit a cj7?
It fit snug and folded easily. I have a YJ supertop on my cj7. It will work fine but you will have to do a lot of fine tuning to make it fit nice. As far as running with the side curtains off, it will work alot better if you wrap something around the part of the top that goes to the tub.
How wide is a JK windshield?
Wrangler TJ Unlimited (’04 – ’06): Windshield width 55″. Round headlights.
What are the dimensions of a Jeep Wrangler JK windshield?
Approximately 54” x 15.5” on the inside at the glass.
Will a TJ bumper fit on a CJ?
No, its not a bolt on deal. The frames on the TJ are wider so the holes are further apart. Also, The frame height is greater on the TJ.
Can you replace the windshield on a Jeep CJ7?
You can replace the windshield on your Jeep Cj7 easily at home using some basic tools. Jeeps are made to withstand a beating, but sometimes even their very sturdy windshields may get chips or cracks in them and require replacement. This job should only take about an hour of your time.
How do you put a windshield on a Jeep Cherokee?
Put the windshield on the frame from outside the Jeep, making sure the ends of the rope are hanging inside the Jeep. Push on the glass from outside the vehicle while a helper pulls on the rope from inside the Jeep, simultaneously working the molding over the frame from inside the vehicle. This will seat the windshield.
What’s the best way to replace a windshield?
Unbolt the windshield using a 3/8-inch socket wrench, and set it aside. Spray the replacement windshield with glass cleaner to make it easier to wrap the molding around it. Wrap replacement windshield molding around the windshield. Put a 15-foot 1/4-inch nylon rope into the seam in the molding and leave 12 inches hanging out on each end.
Where can I find an intact windshield for sale?
Visit your local junkyard to see if you can find an intact windshield for sale. This will save you some money. Unbolt the windshield using a 3/8-inch socket wrench, and set it aside. Spray the replacement windshield with glass cleaner to make it easier to wrap the molding around it.