Why is my Toyota Sienna sliding door not closing?
2004 Toyota Sienna Sliding Door Cable. My door remained in the open position over the weekend and would not close. The manual override feature would not allow use to close the door. Cost to repair at the dealer is over $1,800. This is pretty sickening considering the van is only 5 years old.
Is there a power door switch on a Toyota Sienna?
I’m not familiar with the 2002 (1st Generation) Sienna, but in the 2004 (2nd Generation) Sienna, there is an “on/off” switch that controls the power to the power doors (if so equipped). This power switch is different and separate from the button (s) that open (s)/close (s) the door.
What to do when your side door won’t open?
The only way you can get the door open is to pull the handle and then hold it for two or three seconds. This happens when the latch motor fails, which is fairly common in Toyota Siennas.
How to reset the power door battery on a Toyota Sienna?
Step 1 Press the sliding door control button on the Sienna’s dashboard so that the red line on the button is illuminated. Close the sliding doors. Raise the hood of the van, and disconnect the negative (“-“) battery cable with a wrench. Wait 3 to 5 minutes, then reconnect the cable.
What does CSP stand for in Toyota Sienna?
It is a Customer Support Program (CSP) extended warranty meant to enhance Sienna ownership experience and satisfaction. It covers the power sliding door latch assembly and/or the power sliding door cable assembly on certain model Sienna’s.
Can a broken cable be replaced on a Toyota Sienna?
Replacement of your broken cable should be covered at no cost under a service campaign that covers repairs to the sliding doors for up to 10 years after the vehicle in-service date. The service campaign is the result of a class action suit which is the subject of previous threads on this forum. The local dealer flat out refused to do it.
Where is the button on the side of the sliding door?
Note: At some point you will either want to disconnect the positive battery terminal from your battery or simply put the sliding doors in manual mode so you can manually open and close your sliding door as needed to complete the repair. The button to put the sliding doors in manual mode is located at the left knee of the driver:
What are the bolts on a sliding door?
Two of the three bolts on the rear latch of the sliding door had pulled through the sheet metal, preventing the rear part of the door from latching. I used two washers and slightly longer bolts.
What’s the name of the sliding door on a Sienna?
(Playback ID: zpBDlbdDS0SWKmL6) An error occurred while retrieving sharing information. Please try again later.
How to open driver side manual sliding door?
How to open Toyota Sienna Driver side Manual sliding door if stuck. – YouTube How to open Toyota Sienna Driver side Manual sliding door if stuck. If playback doesn’t begin shortly, try restarting your device.