Why is my Speedo not working on my GSX-R?
There is a common problem with KI Harness Connectors behind the front right cowl ! Take the right hand fairing cover off. Under the right hand inlet duct are three connectors one is not water resistant and water runs down the harness and corrodes out the connectors.
What happens when the speedometer sensor is not working?
The speedometer sensor is also a critical component in the proper operation of a vehicle’s cruise control. When the sensor is not working correctly, it will not send a signal to the CPU, which impacts the vehicle’s ability to set the throttle for a desired speed.
Why is the tach not working on my Suzuki GSX-R?
The bike is a 2002 1000 and has a power commander3 installed other than that no other modifications has been done with the wiring. Thanks!! I also want to add that when ignition key is turned on the backlight of the gauge cluster is lit up but no display on the lcd and no tach movement.
Why are my Speedo and tach not working?
Under the right hand inlet duct are three connectors one is not water resistant and water runs down the harness and corrodes out the connectors. Did you find the recommended reading relevant to this discussion?
Where can I get a US Speedo speedometer?
Please enter your make, model, year and trim to find the right fit for your vehicle! Located in Flint Michigan, US Speedo is the leading manufacturer of better than OEM quality speedometer restyling products. Since 1999, US Speedo has strived to offer cutting edge technology, ahead of the aftermarket curve.
Can a Honda odometer be copied to a new cluster?
The odometer information can be copied over from the old cluster to the new cluster using Honda HDS, assuming the original cluster is operable. What follows is a hack-around to using HDS, by programming the mileage directly to the chip. You can also opt to merely swap the chips, or copy and paste the program, rather than decode.”
Is it possible to calibrate a Speedo separately?
Yes, but it is not possible to calibrate them separately, as one speed signal drives both the speedometer and the odometer. On most bikes, if the speedo is calibrated to be 100% accurate, the odo will register slightly less miles.