Why is my motorcycle clutch slipping?
A clutch slip occurs when the friction plates cannot engage completely, allowing the flywheel to spin at a different rate than the friction plates. Clutch slippage is usually a result of improper adjustments or caused by wear.
Where is the clutch adjuster on a motorcycle?
There’s one adjuster up next to the lever you can adjust by hand. When it’s turned all the way in like this one, you have run out of adjustment, and therefore it’s time to… … hit the adjuster at the other end of the cable. On my R1, that’s down at the clutch, on the other side of the bike.
What happens if you adjust the clutch on a Suzuki Intruder?
An improperly adjusted clutch will cause the clutch to slip and make it hard to shift gears. Pull back the rubber cover of the clutch lever to reveal the lock nut and adjusting screw. Loosen the lock nut with a wrench.
How to service your clutch on a motorcycle?
Remove the clutch plates, which are a mixture of friction and plain steel plates. They are installed in sequence, so make a note on the order in which they come out so when the clutch is rebuilt they go back in the right way. Measure the friction plates with a vernier caliper as per manual specifications. As a rule if the plates smell burnt… 9. …
Is there a problem with my Clutch on my bike?
Problems that only manifest themselves gradually are sometimes hard to spot if you are continually riding the bike.
There’s one adjuster up next to the lever you can adjust by hand. When it’s turned all the way in like this one, you have run out of adjustment, and therefore it’s time to… … hit the adjuster at the other end of the cable. On my R1, that’s down at the clutch, on the other side of the bike.
Remove the clutch plates, which are a mixture of friction and plain steel plates. They are installed in sequence, so make a note on the order in which they come out so when the clutch is rebuilt they go back in the right way. Measure the friction plates with a vernier caliper as per manual specifications. As a rule if the plates smell burnt… 9. …
Problems that only manifest themselves gradually are sometimes hard to spot if you are continually riding the bike.
How do you shorten the clutch cable on a motorcycle?
… hit the adjuster at the other end of the cable. On my R1, that’s down at the clutch, on the other side of the bike. Loosening the nut on the left with a 12mm wrench lets you pull the cable and sheath free. Then you can shorten the sheath a bunch by spinning the right nut with your fingers in the direction that lengthens the inner cable.