Why is my HVAC blower running very slowly?
Typically Red=Low, Blu=Med, Blk=High. The black lead is usually the one needed for a/c operation. Sometimes the motors wear out by having the lubricant in the bearings go dry. In this case the blower wheel will not turn effortlessly and smoothly by hand when the unit is off. If the bearings are dry, then you need a new blower motor.
Where does the ground go in a Honda blower motor?
The blower motor control module (Honda calls it Power Transistor) supplies the ground. The power transistor has 4 wires: two come from the climate control system control unit, one is the ground, one goes to the negative terminal of the blower motor.
How does an air conditioner blower motor work?
As explained in the HVAC Blower Motor Guide, an air conditioner blower motor and assembly is basically the fan inside the air conditioning system that forces the cooled air, via the AC cooling coil, through the vents and into the room space that is being conditioned.
Is the AC blower running in AC mode?
When running in AC Mode, the outdoor fan and compressor kick off just fine. The blower fan seems to kick off as well, though it’s not putting out very much air. I can feel cool air blowing out of the vent but it’s a small trickle, and it’s not enough to keep the house very cool.
Why is there no ground on my blower motor?
It seems, too, that the black ground wire on the blower motor (accessible from just below the dash) has NO ground potential. I ghetto jumpered a 16 gauge wire from the back of the metal clip on the ground wire to the dashboard impact bar/brace and the fan turns at variable speeds with the knob!
How do you test for ground at the blower motor?
Test for ground at the blower motor if there is power indicated at all ranges, but the motor does not function. Most blower motors ground through the case of the motor when it is screwed into place or by a small ground strap from the case to the body of the car.
Why does my blower fan keep getting ground on Black Wire?
The AC system itself has trouble and has a leaky AC compressor (which I also bought a new one to replace!). I broke out the old trusty multimeter and it seems as though the purple wire on the fan motor gets +12v at all times with the fan switch anywhere but OFF.
Why is my blower motor resistor not working?
If there is power indicated on high blower speed, but not low or mid range, the problem is the blower resistor. Test for ground at the blower motor if there is power indicated at all ranges, but the motor does not function.