Why is my harley clicking when I try to start it?
If the the starter still clicks, clean ALL the battery cables and try again. This includes the Positive at the battery and the starter. The negative (ground) at the battery and the ground point. Also check ground strap from engine to frame.
What does it mean when a Harley won’t idle?
Went to start it won’t stay idling unless you either hold the choke out or give it some throttle. Also when you ride their is like a hesitation where the bike kind of jerks like it loses fuel supply forms split second any recommendations. Click to expand…
What was the problem with my Harley Davidson?
After about 15 mins she showed up and said her bike would not stay running. At each stop, it would stall but would always start after the fact. It died in the driveway. We tried to troubleshoot the problem but have been unsuccessful so far. Checked the fuel pump, getting gas, changed the plugs and checked the wires for leaks, no leaks.
What to do when your Harley Davidson is running high?
Jterby, Hoop brought up a good point…also when shutting down the bike, do not blip the throttle…just close throttle, use kill switch and THEN turn ignition off. This allows the ECM to remember all the “idle”, throttle position and store the DTC status.
What does it mean when your motorcycle won’t start?
There are few things that are more disappointing than getting psyched up to go riding only to be hit with realization that your motorcycle won’t start. The engine is turning over, but nothing is happening except for the fact that your frustration level is rising.
What to do if your Harley Davidson won’t start?
Harley Davidson Won’t Start But Cranks HELP! – YouTube Harley Davidson Won’t Start But Cranks HELP! If playback doesn’t begin shortly, try restarting your device.
What to do if your bike won’t start?
1) Place Bike in NEUTRAL. 2) Remove the fuse cover and locate the start Relay. It is the GRAY one. On the inside cover there is a label that will identify the START Relay. 4) Look at the bottom of the removed gray relay closely. You will see pin notation as follows. 87,,87A,,30,,85,,86. 5) Leave the relay REMOVED from the bike.
Where is the start relay on a Harley Davidson?
It is the GRAY one. On the inside cover there is a label that will identify the START Relay. 4) Look at the bottom of the removed gray relay closely. You will see pin notation as follows. 87,,87A,,30,,85,,86. 5) Leave the relay REMOVED from the bike.
Why does my Dyna FXDC bike not start?
Alarm, clutch inhibit & neutral safety all come from the TSSM. The TSSM controls the start relay. 09 Dyna FXDC, got power everywhere. Lights,Horn,Turn`s,Fuel Pump,Dash, Turn the key on, hit the run/stop switch, push the start button and Nothing. Not even a click or a buzz. Bike has been sitting for about 2 weeks.