Why is my CD changer not working in my Cayman?
When I put an ipod magic box in a cayman with pcm sat nav, cd changer it would have tuat fault occasionally on start up. I used to get around it by unplugging the ipod and re-starting the car.
Is the PCM on my 2005 Cayenne working?
I have a 2005 cayenne s. The PCM had been working fine up until the last few months. Nearly everytime you get into the car now and start it up the PCM comes on however the SAT NAV, AMPLIFIER and PHONE will not work. PHONE, NAVAGATION & AMPLIFIER NOT AVAILABLE.
What to do when Garmin sat nav is not working?
With a paper clip press the reset button, which you can find at the back or under your device. Possible Solution #4. Do a force restart. For some Garmin devices, you can achieve a force restart by pressing and holding down the power button.
What to do if your sat nav is showing the wrong location?
If your device has serious internal issues you could take it to a service centre where technicians could replace any damaged or broken parts. Wrong location. If your sat nav is showing the wrong location, whether by a few meters or by miles, you might be experiencing some serious positioning issues.
When I put an ipod magic box in a cayman with pcm sat nav, cd changer it would have tuat fault occasionally on start up. I used to get around it by unplugging the ipod and re-starting the car.
I have a 2005 cayenne s. The PCM had been working fine up until the last few months. Nearly everytime you get into the car now and start it up the PCM comes on however the SAT NAV, AMPLIFIER and PHONE will not work. PHONE, NAVAGATION & AMPLIFIER NOT AVAILABLE.
What is the problem with my 04 Cayenne?
I have the same problem and it has been determined by porsche dealership service center and another porsche tech moonlighting at the shop I usually take my 04 cayenne to that it is the amplifier.
Why does my sat nav say select area?
However, if I try to enter a Destination (or set my Home address), hitting “Address” does nothing – the red border appears round the button and the system beeps to let me know I pressed it, but nothing happens. And on the right there’s a box saying “Select Area”, which is blank underneath then has a button saying “Set Area”.