Why does my Toyota Tundra crank but not start?
All lights was still on and ac, power steering lost and hard brakes, accelerater pedal went to the floor. Now it only cranks not starting. I Changed ( spark plugs, coils was cracked, battery, battery terminals, fuel pump) but only crank no start. Fuel is in one line not two. I need some help. My 2007 Tundra Tundra stopped on me while driving.
What are the issues with my Toyota Tundra?
I’ve had it for about 2 years and haven’t had any issues up until a few weeks ago. Issue 1: About 3 weeks ago was driving home from work about 5 minutes into my drive and I heard a click and the 4 high and low lights started flashing on my dash and the abs light and traction control off lights came on and the truck won’t shift into 4 hi or low.
What should the pressure be on a Toyota Tundra?
WAG is pressure should be around 40psi. There are other fuses to check. Start with the highest amperage ones, 30 A it think, and go from there. I had this issue on a 2010 and it was because I blew a fuse for the trailer harness while on a 500 mile trip.
Why is my Toyota Tundra not shifting to 4HI?
The symptoms of the lights coming on and not shifting to 4hi or lo are the truck being in “limp” mode. Its what the computer does to allow you to keep running the truck to get it to a place to be worked on without letting itself be over-worked.
How many miles does a 2000 Toyota Tundra have?
Hello all! I have a 2000 4.7 liter tundra with 208,xxx miles. I bought it a few months back and haven’t had any problems with it until now. 2 weeks ago I was driving down the highway when Noticed misfiring, loss of power and a flashing check engine light. Took it home and ran the codes, p0305 and p0155.
What are timing marks on Toyota Tundra 4.7?
Check your timing. Pull the top covers, line the marks up and see if anything is off. There are threads in here to show proper timing marks. On the 4.7l its NOT 0. It’s a lil dowel/tit mark on the bottom cover and the letter T on the top for your cam’s.
What makes a truck crank but won’t start?
Has good fuel pressure and spark. Engine will crank and run if you pour gas in the throttle body. Injectors will click when checked with a 9 volt battery but won’t spray has into throttle body. It ran good after replacing intake but three days later it cranked and shut off after a few seconds and wouldn’t crank back.
What to do if your fuel pump won’t start?
Use a circuit tester to check all the electrical connections to the fuel pump. Turn the key to ON. If you see a current, then it is not the pump. If there is no current, check the fuse.
When to use no crank, no start?
Whenever you have a no start condition when attempting to start your vehicle it’s important to make the distinction between “no crank, no start” and “crank, no start” situations as they are treated differently.
Why is there no check engine light on Toyota Tundra?
No check engine light at all, even in the “ON” test position. Can not connect to ECU, even Toyota can’t connect. It has been at the Toyota dealer for two week now and they still don’t know what the issue is. They had a new ECU ready to install but they tech decided to test it first and it did not work either.
Can a Toyota Tundra connect to the ECU?
Can not connect to ECU, even Toyota can’t connect. It has been at the Toyota dealer for two week now and they still don’t know what the issue is. They had a new ECU ready to install but they tech decided to test it first and it did not work either. Having the same issue with my 2012 tundra.
What to do if your Toyota won’t start?
Battery – If the connections on your battery become corroded, there is no longer a connection to the rest of the car. This can keep you from starting. Clean the posts and try to start the car. Additionally, the battery may be dead. Take a battery tester and test the cranking amps to see if they are weak.
Why does my Toyota Prius not start up?
If you get no lights and your battery is working, the ignition switch could be to blame. If you get dash lights, then turn the key to start to see if the lights go out on the dash. If the lights go out, your ignition switch is okay. Starter Connection – Corrosion on the starter can keep the car from starting.
What kind of engine does a Toyota Tundra have?
It had the 5.7 hemi. Every now and then would crank and crank but not start, turn off the key wait a few minutes then start like normal. The dealership could never get it to replicate, never threw a code, no one knew what to repair or replace. Never did figure it out, sold it in 2011.
How often does a Toyota Tundra start up?
Toyota says clean the throttle body. I cleaned with a toothbrush and throttle body cleaner. Thought it was fixed but three weeks later it did it again. Sometimes it won’t happen for six months and sometimes it all happens twice a month.
What is the towing capacity of a Toyota Tundra?
With its available 10,200-lb. towing capacity, deck rail system, and 38-gallon fuel tank, Tundra is built for the worksite and the weekend. 1794 Edition interior featuring JBL ® [jbl] Audio and Apple CarPlay. ® [carplay] Screen depiction accurate as of summer 2019.
How did the battery in my Toyota die?
Battery died.. Changed it.. Now won’t idle. Came out after a couple hours of being parked and my truck wouldn’t turn over. the interior lights were dim so I tried to jump it but it didn’t work. So I went to Pep Boys to get the battery tested and it was dead.
How does the cold start injector work on a Toyota?
The cold start injector most certainly works at temperatures above 32deg. The cold start injector time switch provides a ground circuit for the injector that allows the injector to spray fuel during cranking to help start the engine. The time it allows the fuel to spray is based on what the temperature is.
Are there any problems with the Toyota Tundra?
Symptoms start with hard steering. If the problem is not addressed in a timely manner, it may lead to loss of vehicle control due to the ball joint falling out of the knuckle. In 2007, Toyota recalled hundreds of thousands of Tundras to resolve this issue.
What causes the accelerator pedal to stick on a Toyota Tundra?
After investigating this issue, Toyota found that the sliding surface of the friction level was able to became smooth, creating condensation and causing the accelerator pedal to stick. Toyota recalled 2007-2010 Tundras to install a reinforcement bar in the accelerator pedal to help it operate more smoothly.