Why does my Sam not work in my car?
Getting those connections wet due to water intrusion can also cause problems in equipment routed through the SAMs. And, the SAM under the back seat seems particularly affected when significant amounts of water intrude into the car.
How long does it take for car window tint to dry?
The answer is that the adhesives holding the tinted window film in place take time to dry, and until they do, friction caused by rolling down the window could scrape film from the glass. Leave them rolled up at least two to four days. 1. Be Patient With Window Tint Bubbles
Where does the right Sam go in a Mercedes?
The right SAM in the engine compartment deals with all right front lights and the side light – except low beam (which comes from the left SAM), and also the lights in glove box, center console storage and eyeglass compartment, ashtray and footwell.
Where are SAM units located in a car?
There are SAM units at each large fuse panel: The two under the hood and the one under the right side of the rear seat. Fuses and relays connect to them. In addition, the devices called “electronic fuses” are located in them.
How long can you not drive after 30 hours of service?
The break may be satisfied by any non-driving period of 30 consecutive minutes (i.e., on-duty not driving, off-duty, sleeper berth, or any combination of these taken consecutively). May not drive after 60/70 hours on duty in 7/8 consecutive days.
How many hours can you drive in a sleeper berth?
All sleeper berth pairings MUST add up to at least 10 hours. Drivers are allowed to extend the 11-hour maximum driving limit and 14-hour driving window by up to 2 hours when adverse driving conditions are encountered.
How many hours can you drive on duty?
Drivers are allowed to extend the 11-hour maximum driving limit and 14-hour driving window by up to 2 hours when adverse driving conditions are encountered. Drivers are allowed to extend the 10-hour maximum driving time and 15-hour on-duty limit by up to 2 hours when adverse driving conditions are encountered.
What’s the best way to dry paint on a car?
Eliminate all signs of rust with a wire brush or 220 grit sandpaper. Then apply an anti-rust cleaner. Dry the area thoroughly with a soft cloth or a hand dryer held about a foot away from the surface. Ideally, the drying temperature should be between 65 and 75 degrees Fahrenheit.
Where is the left Sam in a Mercedes?
The left SAM in the engine compartment deals with all left front lights and the side light – except low beam (which comes from the right SAM), further rear air outlet illumination and glove compartment lock illumination.
What is SAM module and how do you change it?
CAN B is the interior (or body) data bus; CAN C is the engine/chassis data bus; and CAN D is the diagnostics data bus. One can see that a problem may occur at the :surrender::bowdown: control; at the component being operated; somewhere in the CAN bus; or in the SAM itself (including fuses and relays).