Why does my Hyosung GV650 make a bad noise?
Many items could cause this form Gudgeon pin to bottom end bearing even a bent con rod would make a bad noise quite hard to pin down unless one is with the bike to check it out first hand. Knocking engines are better off getting looked at rather than still been used or even started up.
Why does my motorcycle clutch make strange noises?
When your clutch is worn, you can’t change gear smoothly, i.e. the clutch is stiff. You may also notice your motorcycle making strange noises. If these noises occur at any time when the bike is running, then it is likely something else. However, if you hear noises that were not present previously while changing gear, it is likely worn.
Are there any problems with the Hyosung engine?
The Hyosung products have a lot of electrical gremlins to them due to poor quality components used and many problems are all around the system computer but the engines are good and don’t give many problems at all.
Why does my Hyosung GV650 Aquila sport EFI?
However in saying all of this it could be the case that the chip has failed and one of the memory slots within its design itself has failed and given the overall quality of these bikes the maker finding the cheapest components to make them with is not uncommon.
What to do if your Hyosung GV 650 wont start?
If u havn’t checked the battery with an ohm meter, do so. If the meter reads 12.50 or higher start looking at your starter. The solinoid would click and a bad starter would nothing. You could try tapping on the starter with a small hammer while pressing the start button. If it starts or at least turns over, u need a starter.
What are the most common problems with Hyosung bikes?
1. Cracked or broken Plug cap 2. Front sprocket nut comes off from the bolt. 3. Engine oil (EO) gets low if one travel long distance. i.e. I will need to top up EO If I travel about 500KM. 4. Hard to free / Neutral gear when the bike is in stationary position. i.e. Gear 1 or 2 to N. Read the article below on how to fix this.
However in saying all of this it could be the case that the chip has failed and one of the memory slots within its design itself has failed and given the overall quality of these bikes the maker finding the cheapest components to make them with is not uncommon.
Are there any problems with the Hyosung Naza blade?
These problems are based on 2014 GT250R that I’ve gathered online based on other Hyosung users. Hyosung / Naza Blade common problems: 1. Cracked or broken Plug cap