Why does my engine die when the blade is engaged?
With the engine off. try to spin the blade to see if it is free. Why does my engine die when the blade is engaged? Was this answer helpful? Was this answer helpful? Scott Robuck will be eternally grateful.
What causes a 2 stroke engine to stop?
There can be several causes of this: 1 Water in the fuel. 2 Old fuel evaporated gumming up carb. 3 Debris in carb plugging up the jets. 4 Carburetor float stuck.
What causes a car to die when making a left turn?
Turn the battery around– if it’s a battery short then it will start dying on left turns. Does this happen when the gas gauge reads a quarter tank or lower? Pontiac Bonnevilles had this problem in the early 90’s. Seems the gas tank lacked baffles which allowed gas to slosh around away from the the fuel pump’s pickup tube on right hand turns.
Why does my car stall when I turn the a / C on?
If not working properly, the engine may not cope with the loads produced by various systems in the car. More specifically, it may be too low to run the A/C and hence it stalls when turned on. How does the air conditioning system affect my car?
What happens to the engine when you stop the car?
Once the vehicle is stationary the engine is killed until the driver either dips the clutch and slots a gear (on a manual vehicle; to activate it the driver needs to put the transmission into neutral) or you come off the accelerator pedal and onto the brake and stop the car (on a vehicle with an automatic transmission).
Why does my car shut off after a sharp turn?
You may notice that every time you drive over a bump on the road or take a sharp turn, the radio, lights and engine suddenly shut off. This is not only frustrating but a safety issue. After a few minutes, the engine and the rest of the electrical accessories may start working again.
There can be several causes of this: 1 Water in the fuel. 2 Old fuel evaporated gumming up carb. 3 Debris in carb plugging up the jets. 4 Carburetor float stuck.
What happens when the cutting deck is engaged on a riding mower?
Solution If the engine dies when the cutting deck is engaged, there is likely one of the following three possible scenarios: The riding mower is in a reverse gear. If the mowing deck is engaged and the unit is in reverse, the mower will shut down as part of a safety feature.