Why does my car stall when I shift to reverse?
The engine may stall when shifting the automatic transmission into reverse. This is commonly caused by a clogged transmission cooler line or fluid cooler.
Why does my car stall at highway speeds?
The engine may start and idle fine, but run out of power or even stall at highway speeds. If the engine starts right back up after stalling, the likely cause is low fuel volume delivery because of a weak pump. If the engine is running normally one minute, but suddenly quits, loss of ignition may be the problem.
Can a stalling engine be intermittent driveability?
Intermittent driveability problems of any kind are always a challenge to diagnose. When a customer brings you a vehicle and complains of a stalling problem, you may not have much to go on other than their description of what’s happening and when it happens.
What to do when engine stall Idle Stop?
Aim for the little air bypass holes in the throttle opening. Use the small plastic tube that attaches to the nozzle on the aerosol can to aim the cleaner directly into the bypass port (s). Let the cleaner soak for at least 10 minutes before giving it another blast of cleaner.
Why does the engine stall when I put the car in reverse?
If the engine stalls, it may be caused by a faulty idle control valve, bad O2 sensors, or clogged fuel injectors. In regards to the “pan”, we’re not sure what you are referring, so it may be a good idea to contact one of our local professional mechanics to complete a battery inspection to determine what’s going on with your 2010 Ford Focus.
The engine may start and idle fine, but run out of power or even stall at highway speeds. If the engine starts right back up after stalling, the likely cause is low fuel volume delivery because of a weak pump. If the engine is running normally one minute, but suddenly quits, loss of ignition may be the problem.
Intermittent driveability problems of any kind are always a challenge to diagnose. When a customer brings you a vehicle and complains of a stalling problem, you may not have much to go on other than their description of what’s happening and when it happens.
Aim for the little air bypass holes in the throttle opening. Use the small plastic tube that attaches to the nozzle on the aerosol can to aim the cleaner directly into the bypass port (s). Let the cleaner soak for at least 10 minutes before giving it another blast of cleaner.