Why does my car make a rattling sound when I drive?
In some cases when you drive on rough roads, a rattling sound will not come from a suspension component, but perhaps a loose exhaust bracket or perhaps a loose bushing somewhere.
Why does my Dodge Durango make a rattle sound?
Hello, Any time there is a problem with the Anti-lock Brake System or the ABS in any vehicle, including your Dodge Durango, the traction control will automatically disable and display the light you are seeing. This is due to the… Clutch not working properly.
What to do if your front Suspension rattles?
Insert the replacement throttle position sensor (TPS) and check with the computer scan to see if it is working correctly and adjusted properly. You may need to relearn throttle position and idle for your vehicle.
What makes a rattle sound when you go over a bump?
Whenever I go over a big dip or down a dirt road with a series of bumps I can hear a almost metal like rattle/slapping noise from the front suspension (almost like the sound of worn sway bar bushings).
Why does my car make an awful noise when I sit at a stop light?
As the exhaust system ages, sometime the heat shields start to rust at the hold-down points and become loose. If this is your problem, the engine vibrations will cause an awful noise as you’re sitting at a stop light or as your car is idling in the driveway warming up.
Why is my car making a loud squealing noise?
This serpentine belt is dried and cracked on the backside of the belt and was making a loud squealing noise. This serpentine belt is dried and cracked on the backside of the belt and was making a loud squealing noise, the ribbed side was cracked just as bad.
Why does my car make a lot of noise when idle?
If belts only squeak when damp, they probably just need adjustment. If they squeak constantly, they probably need to be replaced Low knock at idle, noise gets louder as RPM’s increase under a load Piston wrist pin or worn crankshaft bearing.
Why does my CV joint make a clicking noise?
Eventually it will split open and allow specks of dirt and debris to enter the joint. Once foreign matter mixes with the grease, the damage begins, and it is only a matter of time before the CV joint starts to make a clicking noise when turning.