Why does my bike stall when put in first gear?
Assuming the clutch is adjusted correctly with the right ammount of free play, stalling when selecting first gear from cold is usually a case of sticking clutch plates. This invariably happens with my YamahaXJ600.
When do I drop from first to neutral my bike stalls?
This post is not being displayed . When I initially start up the bike and drop from neutral to first, the engine stalls pretty much every time. It only happens once and then I can drop down to first with no problems during a ride.
Why does my car stall after a few seconds?
A clogged carburetor is most commonly caused by leaving fuel in the engine for a long period of time. Over time, some of the ingredients in the fuel may evaporate, lea…ving behind a thicker, stickier substance. This sticky fuel can clog up the carburetor and cause the engine to stall.
Why does my motorcycle engine stall when warm?
And the problem is often worse on a hot day. The dreaded stalling issue when the engine is warm is the most common idle problem and it is mostly related to the very lean air/fuel ratio on the modern fuel injected motorcycle engine. Why does my motorcycle stall at idle when the engine is warmed up and at operating temperature ? – Low compression.
This post is not being displayed . When I initially start up the bike and drop from neutral to first, the engine stalls pretty much every time. It only happens once and then I can drop down to first with no problems during a ride.
And the problem is often worse on a hot day. The dreaded stalling issue when the engine is warm is the most common idle problem and it is mostly related to the very lean air/fuel ratio on the modern fuel injected motorcycle engine. Why does my motorcycle stall at idle when the engine is warmed up and at operating temperature ? – Low compression.
What to do when your bike stalls in first gear?
I just got into the habbit of pulling it out by hand in the morning. At the end of the day either park it on the centre stand or diconect the switch from the frame and leave it hanging until next morning and if your bike starts fine then you know what the problem is. This post is not being displayed .
What does it mean when check engine light comes on?
This will give you a location to start that is causing the engine to stall out. If you get the code P1684, then check the battery cables to see if they are loose or corroded. The code P1684 means that there has been a loss of electrical power to the ECM (power).
Why does my Ducati 1200 have a clutch problem?
Ducati 1200 and 1260 bike models both have a common issue with their clutch master cylinders, hence a problem with the clutch. The master cylinder of this bike model is prone to leaks that will reduce the level of fluid needed for adequate movement.
What causes a motorcycle to stall when the clutch is released?
Please try again later. This is a detailed description of a classic motorcycle problem, characterized by an engine stall when the transmission is in gear and the clutch handle released. The ignition wiring diagram is shown for a Kawasaki VN800 motorcycle, but many bikes with sidestands will have similar variations.
What to do when your clutch stalls in first gear?
My friend used to have this problem, when he used to do cold starts hed fire his bike up then apply the back brake, hed then rev the engine grab the clutch and put it into gear, it would make a big clunk but then be fine for the rest of the day. This post is not being displayed . The clutch is sticking overnight, do you have the correct oil in it?
Assuming the clutch is adjusted correctly with the right ammount of free play, stalling when selecting first gear from cold is usually a case of sticking clutch plates. This invariably happens with my YamahaXJ600.
My friend used to have this problem, when he used to do cold starts hed fire his bike up then apply the back brake, hed then rev the engine grab the clutch and put it into gear, it would make a big clunk but then be fine for the rest of the day. This post is not being displayed . The clutch is sticking overnight, do you have the correct oil in it?
Please try again later. This is a detailed description of a classic motorcycle problem, characterized by an engine stall when the transmission is in gear and the clutch handle released. The ignition wiring diagram is shown for a Kawasaki VN800 motorcycle, but many bikes with sidestands will have similar variations.