Why does Honda still use the timing belt?
Because if the break you are dead in the water but no damage is done to the motor. Unlike the chain, when it breaks it fouls up the inside of the engine. Honda still uses a belt on their V6 engines.
Why do you need to change your timing belt and water pump?
This might be preceded by a ticking noise coming from the engine bay. In addition, the gasket separating the timing cover and engine block may fail over time, causing oil to leak out. It is technically possible to replace your car’s timing belt and water pump yourself.
How long does a Honda timing chain last?
The timing chain should last you the life of your engine although there are occasions when it could fail and wear out on you. Typically, however you can expect the time you change the last over 200,000 miles. Timing belts are usually composite rubber belts with teeth on the inside to grip the gears of the camshaft and the crankshaft.
What happens if your timing belt skips or breaks?
In an interference engine, the valves and piston share the same airspace and the timing belt keeps them from touching. This is why you’ll have a major engine failure on your hands if the belt breaks or skips.
How often do Honda timing belts need to be changed?
The timing belt will require some routine maintenance and eventually will have to be replaced because they will wear out. Again, you’ll have to check your specific model and year to know how long the timing belt last, but Honda says that their belts typically get changed between 60,000 miles and 100,000 miles.
The timing chain should last you the life of your engine although there are occasions when it could fail and wear out on you. Typically, however you can expect the time you change the last over 200,000 miles. Timing belts are usually composite rubber belts with teeth on the inside to grip the gears of the camshaft and the crankshaft.
Where do you put the timing belt on a Honda V6?
With the belt in place, tighten the idler pulley bolt to 38 ft.-lbs. 13. Next, remove the retaining tool or pin from the auto-tensioner. Install the engine mount bracket to the front of engine. If you have a timing belt guide plate, install it with the concave surface facing out.
Why does the timing belt make a noise?
It’s not a very common problem, but if you’re ever chasing a report of a noise in the timing belt area, or a slipping belt noise when the belts look good, these pulleys have been known to separate. Look closely with the engine running to see if the outer ring (where the drive belt rides) is running true to the hub.