Why are the lights on and off at the same time?
If both are in the same position (either off or on) the lights are on. If they are opposite the lights are off. Other than turn one switch upside down, what could be the wiring issue?
How do you turn off all the lights in Your House?
By pressing a button, its light and those of the (non-diagonally) adjacent buttons will change (switch on if it was off, and vice versa). Given a pattern of lights, you have to switch them all off by pressing the correct buttons.
When do you use position lights in Alaska?
14 CFR 91
Why do 3 way light switches not have on and off positions?
3-way switches don’t have on/off positions, flipping the switch at either end should cause the state of the light to change, because of that up for on, down for off doesn’t apply. – Tyson Apr 15 ’17 at 22:40 Are you sure you have the description of the problem stated correctly? 3-way switches normally do not have an OFF and an ON position.
What to do when light fitting comes on and off?
If both L1 and L2 have conductors in them, there must be another switch somewhere, or it has been removed. If you can’t locate the other switch, just swap the L1 and L2 over. Find the live and switched live coming from your light switch and swap the wires around within the ceiling.
How can I tell if my light fitting is live or switched?
Find the live and switched live coming from your light switch and swap the wires around within the ceiling. If its been done correctly then this should be the grey sleeving with a red wire (live), an earth and a black wire that should have a little red sleeve over it indicating its a switched live. (live when the switch is pulled).
What happens when you turn off an LED light bulb?
It won’t damage your fitting or bulb, but it can be annoying and will cost you in electricity (albeit a very small amount). After switching to LEDs or when replacing a faulty LED lamp in some cases the LED continues to glow weakly after turning the light switch off.
What’s the easiest way to turn off a pilot light?
If you need to perform maintenance, turning off the pilot light is as simple as turning off the gas supply to the appliance. While each type of appliance has a few additional steps you need to complete, they all require you shutting off the gas.