Where should I start reading resistors?
Always read resistors from left to right. – Resistors never start with a metallic band on the left. If you have a resistor with a gold or silver band on one end, you have a 5% or 10% tolerance resistor.
Where do we start reading the color stripes of a resistor?
You should read the stripes from left to right. The first stripe is the one that’s closest to one end of the resistor. If this stripe is on the right side of the resistor, turn the resistor around so the first stripe is on the left. Look up the color of the first stripe to determine the value of the first digit.
Can you tell if a resistor is bad by looking at it?
Your meter will read it as open circuit (infinite ohms). Or maybe it’s a 0.1 ohm current sensing part. Your meter will read it as a short circuit. If it’s a larger resistor with leads and it looks and smells burnt, assume it’s bad.
How to find the color of a resistor?
Resistors are color coded. To read the color code of a common 4 band 1K ohm resistor with a 5% tolerance, start at the opposite side of the GOLD tolerance band and read from left to right. Write down the corresponding number from the color chart below for the 1st color band (BROWN).
Which is the first band of a resistor?
The most commonly used colors for resistor tolerances are gold, silver, brown, especially gold and silver bands, which are rarely used as the first band of the resistor color band. So as long as there are gold and silver bands on the resistor. It can be considered that this is the last band of the color band resistor.
How do you find the second number on a resistor?
Look at the color of the second band to find the second number. To the immediate right of the first colored band is a second colored band. Locate the band and identify what color it is. Then, consult the resistor color chart to identify the second number in the value of the resistor.
How do you identify an axial resistor in Photoshop?
Axial resistors are cylindrical with leads extending from each end. Look at the resistor so the group of 3 or 4 color bands are on the left side. These are sometimes followed by a gap, then an additional color band. Read the color bands from left to right.
The most commonly used colors for resistor tolerances are gold, silver, brown, especially gold and silver bands, which are rarely used as the first band of the resistor color band. So as long as there are gold and silver bands on the resistor. It can be considered that this is the last band of the color band resistor.
Which is the correct way to identify a resistor?
Look at the resistor so the group of 3 or 4 color bands are on the left side. These are sometimes followed by a gap, then an additional color band. Read the color bands from left to right.
Look at the color of the second band to find the second number. To the immediate right of the first colored band is a second colored band. Locate the band and identify what color it is. Then, consult the resistor color chart to identify the second number in the value of the resistor.
How to read a 4 band resistor color code?
How to read a typical 4-band, 5-band and 6-band resistor 4-Band: Reading the resistor from left to right, the first two color bands represent significant digits, the third band represents the decimal multiplier, and the fourth band represents the tolerance. 5-Band: The first three color bands represent significant digits, the fourth band