Where is the U-joint on a Honda CRV?
Once I had the old Honda CR-V drive shaft u-joint removed, I cleaned up the yolk to expose the groove where the c-clip would sit, but there is no groove. On closer examination, the Honda u-joint is staked onto the yolk.
How much does a Honda CRV ujoint cost?
Honda CRV Blowout! TUS-9B (430-9b)97-01, TUS-9A (430-9a)01-09. $20.00 ea. Steering ujoints! 15mm x 40mm ujoints, Fits most domestic vehicles. 16mm x 40mm ujoints Some Dodge Durango, Dakota and some import applications.
Can you replace the drive shaft on a Honda CRV?
This Site Was Built With You In Mind! Honda CR-V drive shaft u-joint replacement should be a straight forward job, but unfortunately it’s not on a Honda CR-V, in fact, it’s impossible without changing the drive shaft yoke. But there is an alternative, and it is much easier then replacing the u-joint.
Are there universal joints for the Kia Sorento?
KIA Sorento universal joints 03-06 2WD on sale! $20.00 TUS-10 (430-10) ujoints, Subaru Legacy,Forester,SVX,Baja, Toyota Highlander,Rav 4, Sienna AWD, Corolla. Lexus RX300,330,350 universal joints on sale! Long Tail Motorujoint (Go Devil) Type. (all different sizes) 1410-1480 combination ujoints.
Once I had the old Honda CR-V drive shaft u-joint removed, I cleaned up the yolk to expose the groove where the c-clip would sit, but there is no groove. On closer examination, the Honda u-joint is staked onto the yolk.
This Site Was Built With You In Mind! Honda CR-V drive shaft u-joint replacement should be a straight forward job, but unfortunately it’s not on a Honda CR-V, in fact, it’s impossible without changing the drive shaft yoke. But there is an alternative, and it is much easier then replacing the u-joint.
What causes a Honda CRV boot to shake?
The inner CV joint is most likely to be the part of the CV shaft that has gone bad. More often than not, a bad CV joint is caused by a torn boot. The protective boot goes over the CV joint and keeps oil in and debris out. It is really easy to tell if the boot is bad.
Why does my Honda CRV brake line keep sticking?
A stuck brake caliper can happen to any vehicle. It can happen for a number of reasons, such as the piston in the caliper getting stuck, or a crimped brake line. More than likely, you’ll need to replace the caliper. Here’s more on how to tell if your CR-V’s brakes are sticking.