Where is the transmission drain plug on a Harley?
The drain plus is located between the shock absorbers, underneath the transmission. Use the ratchet, 3-inch extension and 5/8-inch socket to remove it. Once it’s loose, finish removing the drain plug by hand to prevent it from falling into the drain pan.
How often do you change transmission fluid on a Harley?
How often should I change the tranny oil in my Harley? According to the manufacturer’s service manual, you should change the engine oil at 5,000 miles. Primary oil should change at 10,000 miles, and trans fluid at 20,000 miles. A transmission oil change should happen every year.
How much oil goes in a Harley transmission?
When filling the transmission, use Harley-Davidson TRANSMISSION LUBRICANT (Part No. 99892-84 (qt.) or 99891-84 (gal.)). The transmission fluid capacity is approximately 24 ounces (0.71 liters). Inspect o-ring for tears or damage.
How do you check transmission fluid on a Harley?
Straddle your Harley and hold it level, off the side stand, for 20 to 30 seconds. Remove the transmission dipstick and wipe it clean before reinserting it into the block. Do not screw it in. Insert the dipstick until the top of the threads is resting on top of the hole to check the transmission fluid in a Harley.
How do you check transmission fluid on a Harley Davidson?
How often should you change the primary fluid in a Harley Davidson?
Registered. Thanks for the heads=up and changing my P/Oil when the bike is HOT. So you change your P/Oil every 10,000 miles that a long time.
Do you check Harley transmission fluid on the kickstand?
The transmission oil is checked with the motorcycle on a level surface and on the kickstand. The transmission oil level is correct when between the Add and Full marks on the dipstick.
How do you change transmission fluid on a Harley Davidson?
While the transmission fluid is draining, clean the drain plug. Make sure to remove all the debris and check the plug for damage. Slide the new O-ring onto the transmission plug and run it all the way to the bottom. Re-install the drain plug. Snug it up by hand, then use the torque wrench set at 14-21 foot-pounds torque to tighten it.
How do you change the fluid in a Softail?
Place a funnel into the fill plug hole and pour 22 oz. (650 milliliters) or 32 oz. (946 milliliters) of fluid into the transmission (differs by year). Different year models use different methods to check the fluid level.
How much fluid do you put in a transmission?
Place a funnel into the fill plug hole and pour 22 oz. (650 milliliters) or 32 oz. (946 milliliters) of fluid into the transmission (differs by year). Different year models use different methods to check the fluid level. Some years need to be checked with the bike level while others need to be checked on the kickstand.
What happens when you change the transmission fluid?
These shavings mix with the fluid and reduce the fluid’s ability to lessen friction between surfaces. Overheated transmission fluid from racing or engine overheating damages the fluid, making replacement mandatory. Changing the transmission fluid can be easily accomplished in the garage at home with basic tools.