Where is the timing belt on a Toyota Camry?
Begin routing the timing belt in this order: crankshaft gear, idler pulley, water pump, then camshaft gear. Once the belt is routed around the camshaft gear, an alligator clip can be used to keep tension on the belt between the camshaft and crankshaft. Finish installing the belt onto the remaining pulleys.
How do you change the timing chain on a car?
1. Disconnect negative battery cable. Drain cooling system. Remove windshield washer fluid reservoir. Rotate accessory drive belt tension-er clockwise (viewed from timing chain end of engine) to release tension from accessory drive belt. Remove accessory drive belt. Remove mounting bolts and generator. 2.
What’s the best way to adjust cylinder timing?
Community Answer. Set the first cylinder to top dead center on the compression stroke. Set the distributor to fire at the top (this is considered 0 degrees advance/retarded). If you want to advance/retard timing, turn the crank an angle amount equal to what you want, or place a timing tape and use a timing light.
What’s the best way to adjust the timing of a rotor?
To adjust your timing, all you need to do is turn the distributor housing one direction or the other, depending on whether or not you want to advance or move back the timing. If the rotor turns clockwise, you’ll advance the timing by rotating the distributor counterclockwise, and vice versa.
Working clockwise, route the belt around the outside of the oil pump pulley, then behind the tensioner. While holding the belt with one hand, route the belt around the back of the idler pulley on the right side of the engine (while looking down at the engine), then around the water pump sprocket.
What kind of engine does a 1999 Toyota Camry have?
The 1999 Toyota Camry uses a 2.2L 4-cylinder engine. This engine is a freewheeling engine, which means that should the belt stretch beyond the scope of the tensioner, it is unlikely that extensive engine damage will occur. It takes about three-and-one-half hours to complete the process.
Where are the spark plugs on a Toyota Camry?
Number the spark plug wires so you know where they go when you put the Camry back together. The cylinder order is 1-2-3-4, with the No. 1 cylinder wire closest to the timing belt. The firing order is 1-4-3-2. Pull the wires off the spark plugs. Remove the spark plugs using the spark plug socket.