Where is the thermostat located on a Honda Civic?
Once you have the coolant drained from your engine, you can begin our how to guide on how to replace a Honda Civic thermostat. The thermostat housing on your Honda Civic is located behind the distributor and mounted just above the starter.
What to do when your 1998 Honda Civic overheats?
When the thermostat malfunctions, the spring fails to compress and the engine ultimately overheats. When this happens, your must replace the thermostat in your 1998 Honda Civic. Drive the Honda Civic onto a set of ramps and secure the parking brake. Raising the front of the Civic allows more room to work under the engine.
How do you replace the radiator cap on a Honda Civic?
Once the air bubbles are out of the system, replace the radiator cap. Make sure the reservoir is still full, and then allow the car to run until warm. Allow the car to run for 3 to 5 minutes while warm. Turn off the car, and allow it to cool down.
How to replace the thermostat on a 1998 radiator?
Place the thermostat housing over the gasket and thermostat, and secure it with both 10mm bolts. Slide the radiator hose back onto the thermostat housing, and secure it with the radiator hose clamp. Remove the radiator filler cap located on top of the radiator. Pour the coolant back into the radiator. Put the radiator cap back on.
How do you replace the thermostat on a Honda Civic?
Loosen the hose clamp from the thermostat housing with a screwdriver and remove the hose. Remove the three bolts securing the housing with a wrench. Remove and discard the thermostat. Clean the housing of any gasket remnants with a putty knife. Insert the new thermostat into the housing.
What should I do if my Honda Civic overheats?
When you have confirmed that the radiator has sufficient coolant, the indication is that the thermostat is failing or has failed. A stuck thermostat causes overheating which can damage the engine, sometimes beyond repair. Buy a new thermostat at an auto parts store and replace it at home in minutes. Raise the hood of your Civic.
How to replace the thermostat in a 1998 car?
Place the spring end of the new thermostat inside the engine block, and hold it there with one hand. Place the thermostat gasket over the thermostat, and hold both in place with your hand. Place the thermostat housing over the gasket and thermostat, and secure it with both 10mm bolts.
What’s the best way to install a new thermostat?
Use Hondabond or high-temp RTV silicone gasket maker once both surfaces are dry. Prepare your new thermostat using the rubber isolator, and rub the gasket maker or Honda bond until it gets tacky. Gently reinstall your new thermostat and use both 10mm bolts to secure the housings in place.