Where is the starter relay on a Mercury Mariner?
Ford uses an antitheft system to tell the PCM to energize a starter relay located in the battery Junction box. The image shown here is from a 2008 Ford Escape, Mercury Mariner. So your first job is to find out whether the no start problem is due to a bad relay or some other component or wiring harness.
What’s the junction box on a 2008 Mercury Mariner?
2008 Ford Escape Junction box which is similar to 2008 Mercury Mariner. Ford uses an antitheft system to tell the PCM to energize a starter relay located in the battery Junction box. The image shown here is from a 2008 Ford Escape, Mercury Mariner.
What was the problem with my Mercury Mariner?
My Mercury Mariner 2010 had starting problems on and off. It turned out to be a faulty INERTIA SWITCH. This switch is often overlooked. I had the mechanic bypass it. Car runs fine now. Check this fix first before changing the starter, etc. Sign In or Register to comment.
Where is the signal switch on a Mercury Mariner?
Preparing document for printing… Page 613 C271 fDoor Ajar Switch, Left Front C526 fPage 449 C527 fPage 763 fTurn Signal Switch: Testing and Inspection fPage 703 fTaurus and Sable f6. Remove the rear seat lower cushion. Taurus X 7. Release the 2 load floor support brackets and position the load floor upward. 8.
Preparing document for printing… Page 613 C271 fDoor Ajar Switch, Left Front C526 fPage 449 C527 fPage 763 fTurn Signal Switch: Testing and Inspection fPage 703 fTaurus and Sable f6. Remove the rear seat lower cushion. Taurus X 7. Release the 2 load floor support brackets and position the load floor upward. 8.
Where are the jumper wires on a Mercury Mariner?
– Tighten the fuel level sensor lock ring until it meets the stop tabs on the fuel tank. fPage 93 ^ Yellow jumper harness wire to VMN07 (GY) and remaining black jumper harness wires to RMN07 (VT) and DMN07 (shield – BK). ^ Only splice into the cut wires heading in the direction of the connector.
What should I remove from my Mercury Mariner?
Remove the rear seat lower cushion. Taurus X 7. Release the 2 load floor support brackets and position the load floor upward. 8. Remove the 4 load floor support-to-floor pan nuts. – To install, tighten to 18 Nm (13 lb-ft). 9. Remove the 2 load floor support brackets. All vehicles 10. Remove the fuel level sensor access cover.
Where does microphone cable go in a Mercury Mariner?
Route microphone cable through existing hole in the headliner, and over to the driver side A-pillar. It may be necessary to slightly drop headliner run microphone cable. Refer to WSM, Section 501-05 for additional information. 4. Install overhead console; ensure microphone cable enters the overhead console trim directly behind microphone as shown.