Where is the starter located on a Jeep Wrangler?
The starter is located on the driver’s side of the vehicle, just above the drive line. It is often covered by a small heat shield.
How can you tell if a jeep starter needs to be replaced?
Check the battery cable to the starter solenoid. This is the large red battery feed to the top post on the starter solenoid on top of the starter. Grab the cable and see if it is tight on the solenoid post. Check the cable for any visible corrosion. Replace the cable if any exists.
What should I do if I need to replace my starter?
Unhook the positive and negative terminals to ensure you can replace the starter without risk of electric shock. Set the parking brake, and chock the wheels. This will prevent the vehicle from rolling, and it’s a good rule of thumb if you decide to jack up the vehicle as well.
How do you remove the ground from a starter?
Unbolt the positive wire from the solenoid on top of the starter. The ground is bolted in with the bottom bolt, so it will be removed when you undo the bottom bolt. Take the bottom bolt out with a socket wrench. While holding the starter with one hand, pull out the top bolt with the other hand. The starter will usually slide out at that point.
Where is the starter fuse on a 2004 Jeep Liberty?
Diagnosing a starter problem on a 2004 Jeep Liberty is not difficult. The fuse and relay for the starter are located on the driver’s side fenderwell in the electrical component box. Under the box’s lid is a diagram depicting the type and location of the fuse and relay for the starter.
How to change the starter on a Jeep Wrangler?
This starter wasn’t really that old only a few years or so. changing the starter is easy, first make sure you disconnect the battery. remove the electrical connections from the starter. Then remove the 2 bolts holding the starter in place and remove. Loading…
What happens when you return a faulty Jeep starter?
Take the old starter back to the parts store for a core credit. Core credit is the money the store added to the cost of the starter; this will be refunded when you return the faulty starter. Isolate the electricity by disconnecting the battery on your Jeep Wrangler.
How to tell if the starter needs to be replaced in a 2004?
Pull this wire off and insert the probe into the small wire connector. Have a helper turn the key to the “start” position. Power should be displayed when the key is in the “start” position only. If there is power and the starter fails to operate replace the starter. If there is no power, check the fuse and relay.
Unbolt the positive wire from the solenoid on top of the starter. The ground is bolted in with the bottom bolt, so it will be removed when you undo the bottom bolt. Take the bottom bolt out with a socket wrench. While holding the starter with one hand, pull out the top bolt with the other hand. The starter will usually slide out at that point.