Where is the SRS sensor?
The location of airbag sensors differs from car to car. The most common location is inside the front bumper or fender, however many modern vehicles have several airbag sensors. They can also be found inside the engine bay, in the passenger seat area, or even in the rear or sides of the vehicle.
How to reset Honda Civic EX coupe SRS light?
1- W/ the igniton switch “off”, insert the paper clip ito the connector 2- Turn the ignition switch to the “ON” position. 3- The SRS light will come on for 6sec & then turn off. Remove the paperclip w/in 4sec of the SRS light turning off. 4- The SRS light will turn on again. Re-connect the paperclip w/in 4sec of the SRS light turning on.
Where is the SRS fuse on a Honda Civic EX coupe?
It’s just to the right of the steering shaft behind the center console. Here is the YELLOW SRS service connector located on the fuse panel. Unplug the YELLOW SRS service connector. All you need is a paper clip, bend it in 1/2 & insert it into the YELLOW SRS service connector (not the actual fuse panel).
Where is the service connector on a Honda Civic EX coupe?
Here is the YELLOW SRS service connector located on the fuse panel. Unplug the YELLOW SRS service connector. All you need is a paper clip, bend it in 1/2 & insert it into the YELLOW SRS service connector (not the actual fuse panel).
What does the SRS light mean on a Honda Accord?
The SRS light is a warning light for your supplemental restraint system (airbags). An SRS light means that there is a problem in the system. The first thing I would check is the fuse for the SRS unit. The only way to check this is with a scan tool of some sort. I used a Solus Pro.
Why is my SRS light not working on my Honda Civic?
I recently had this issue with my 1999 Civic SiR, and it turned out the issue was that the internal contact points of the car horn had corroded. Replacing the car horn, and then resetting the SRS light by disconnecting the battery for about 10 or so minutes fixed things.
The SRS light is a warning light for your supplemental restraint system (airbags). An SRS light means that there is a problem in the system. The first thing I would check is the fuse for the SRS unit. The only way to check this is with a scan tool of some sort. I used a Solus Pro.
Where is the SRS airbag control module located?
In most GM cars it is under the driver or passenger seat. Disconnect the positive battery cable and wait 3 min. You are now safe to unplug the airbag control module harness wiring plugs. All airbag srs components must be installed and connected properly before installing the airbag control module.
How can I tell if my SRS light is on?
The scanner flashes slowly to indicate the first part of the numerical error code and then uses a second quick flash for the second number of the code. I recommend that you check the code and go from there. I’m guessing that it will show a “non-functional” code; this is a common problem.