Where is the SRS plug on a Honda Accord?
(1) Locate MES Plug. It should be located near the driver’s side fuse panel under the dash. The harness is yellow with two wires. (2) Unplug the MES Plug. -Short and hold the leads while you turn the ignition to on. The SRS Light will illuminate for a few seconds then go off.
Why is my SRS light not working on my Honda Accord?
Tried the battery thing, the MES plug light reset and basically nothing works, Most cheap scanners including the Snapon Solus-Pro won’t read air bag .or abs codes.
What does the SRS light on airbags mean?
The SRS light is a warning light for your supplemental restraint system (airbags). An SRS light means that there is a problem in the system. The first thing I would check is the fuse for the SRS unit.
How can I tell if my SRS light is on?
The scanner flashes slowly to indicate the first part of the numerical error code and then uses a second quick flash for the second number of the code. I recommend that you check the code and go from there. I’m guessing that it will show a “non-functional” code; this is a common problem.
Where is the EGR port on a Honda Accord?
Learn how to properly clean clogged EGR ports on a Honda Accord. This article applies to the Honda Accord (1990-2002). The EGR ports on an engine exist to release exhaust fumes into the intake manifold.
What does the SRS light mean on a Honda Accord?
The SRS light is a warning light for your supplemental restraint system (airbags). An SRS light means that there is a problem in the system. The first thing I would check is the fuse for the SRS unit. The only way to check this is with a scan tool of some sort. I used a Solus Pro.
The SRS light is a warning light for your supplemental restraint system (airbags). An SRS light means that there is a problem in the system. The first thing I would check is the fuse for the SRS unit.
How do you clean the EGR valve on a Honda Accord?
Remove the two mounting nuts for the EGR. Flip the unit over and attach it to a vacuum pump. While its valve is open, spray some carb cleaner inside. Figure 10. Clean the EGR valve. Install the gasket for the EGR valve and tighten the nuts. Clean off the fuel injector ends and re-install the rail onto the manifold.