Where is the speed sensor located on a 2009 Nissan Altima?
The sensor is on the side of the transmission housing facing the front. It is on the same side as the starter.
Where are the speed sensors on a Nissan Titan?
While taking out the original axles, we did notice that there were 4 separate speed sensors; one at each wheel. We also noticed that there was a speed sensor in the tail shaft of the transmission. At that time, we did some research on the internet.
How do I replace the wheel speed sensor?
No Æ Replace the wheel speed sensor. 2. Check the wheel speed sensor output signal. a. Raise the vehicle on a hoist. b. Connect the ABS active wheel sensor tester (J-45741) to wheel sensor using the appropriate adapter. c. Turn on the ABS active wheel sensor tester power switch. NOTE:The green POWER indicator should illuminate.
How to test the ABS wheel speed sensor?
Connect the ABS active wheel sensor tester (J-45741) to wheel sensor using the appropriate adapter. c. Turn on the ABS active wheel sensor tester power switch. NOTE:The green POWER indicator should illuminate. If the POWER indicator does not illuminate, replace the battery in the ABS active wheel sensor tester before proceeding. d.
Why does my speedometer not work on my Nissan Titan?
The speedometer did not work. Due to this problem, the motor would go into a limp mode after driving a small distance. It would stay running, but would lose all power. It would take a few seconds to kick back in.
Where is the speed sensor on a car?
Locate the electrical connector from a particular the wheel speed sensor which is near the frame in the wheel well in most cases. Don’t be confused by other wiring harnesses that may lead down to the wheel such as the brake pad wear sensor.
While taking out the original axles, we did notice that there were 4 separate speed sensors; one at each wheel. We also noticed that there was a speed sensor in the tail shaft of the transmission. At that time, we did some research on the internet.
No Æ Replace the wheel speed sensor. 2. Check the wheel speed sensor output signal. a. Raise the vehicle on a hoist. b. Connect the ABS active wheel sensor tester (J-45741) to wheel sensor using the appropriate adapter. c. Turn on the ABS active wheel sensor tester power switch. NOTE:The green POWER indicator should illuminate.
Where is the ABS wheel speed sensor located?
In the image below a stator ring or as it is sometimes called a reluctor can be located inside the bearing hub, rear axle housing, or on the CV joint itself. Slowly rotate the ring to check it for damage or missing teeth. Wheel sensors are magnetic so check for metal shavings around the sensor which can hinder performance.