Where is the reset button on a Jeep Cherokee?
Find the Data Link Connector port next to the fuse panel under the driver’s dashboard. Plug the computerized scan tool into this port. Check the computerized scan tool’s owner’s manual on exactly how to clear the codes and reset the computer because each model is a little different.
How to reset your Jeep engine control module?
3- Once the time has passed you should now turn the headlights “on” and “off” twice to drain the Engine Control Module from any remaining power. 4- Now plug back in the negative terminal and your Jeep ECM should now be reset. To finish off this post , here are a couple of things you should keep in mind.
What’s the noise when you put a jeep in Park?
So when I back up, stop, put the jeep in park I hear a pop/ bang noise. Any ideas? T case / driveshaft slop. How loud is the bang/pop?
What does the computer do on a Jeep Cherokee?
The PCM (power train control module) or computer controls the Cherokee’s ignition, fuel system, emission and other systems. When it detects a malfunction in any of the vehicle’s systems, it will alert you with a warning light on the instrument panel. It will also let you know when your Jeep needs regular servicing.
What should I do if my Jeep Cherokee turns off?
Plus i had my motor rebuilt at 2000thou now 242, runs Great just anoying sensors that are starting to act up but repñace crank sensor first check pos wire from start make sure its good not arking i put 4guage on its better Plus put 4guage ground on bat do the crank sensor if u wanna start it up 11 people found this helpful. 1,030
Can a Jeep Laredo go forward or reverse?
I am having a bit of a situation. I have a 2002 Jeep Grand Cherokee Laredo. Yesterday it was running forward and reverse with no problems. Well this morning as I do every morning, I started it, let it warm up for about 30 seconds or so, when i shift to reverse, guess what….wont go reverse.
Why does my Jeep WK2 surge while driving?
It mainly did it going up hill or at around 40 mph at 1300 rpms. Just like the WK2 guys with the 3.6 engine. They are experiencing something similar with having to adjust the way they drive due to lack if power and not so good tuning. It’s going to surge/buck regardless what you do because of lack of power and tunning.
Why does my Jeep turn off while driving?
138 people found this helpful. If your jeep over heated after all things listed in this form have been checked, have a mechanic check the motor head gaskets to see if they are damaged, air might be leaking out from it. Usually happens if it overheats or overheated in the past and the gaskets got blown or are having pressure come out even a little.