Where is the relay for the tail lamp?
The tail lamp relay is relay number B, 2md from the left in the RH junction box 15. TAILLAMP RELAY (a) Measure the resistance according to the value (s) in the table below. If that is not the cause, I would check the headlight dimmer switch (sounds more like it because of your dash light being out as well Hope this helps, good luck.
Where are the relays for the dash lights?
If your dash lights work but won’t dim and your running light won’t work and your license plate lights are out. Then there are 4 relays directly above the glove box. you can’t see them until you drop the panel. There are three 10mm bolts just in front of the latch. There are 4 relays, 3 that look the same and one that is different.
Why is my matrix tail light not working?
The relay behind the glove box was out of the socket and I had to push it in to make the connection. My 2007 Matrix tail light would not work. Fuse was okay and bulbs were new. The hardest part of the job was to find the fuse boxes and relay box (fuse box underneath hood, under driver side and relay behind glove box).
Why are the tail lights not working on my Camry?
My 03 camry had the same issue. No gauge lights, tail lamps, and no parking lights. The tail lamp relay is on the back of the fuse box ( middle one on the outside,) but that wasn’t the problem. Under the hood I swapped the horn relay with the ECU relay and it fixed the problem. Those relays are side by side and they’re all the same.
The tail lamp relay is relay number B, 2md from the left in the RH junction box 15. TAILLAMP RELAY (a) Measure the resistance according to the value (s) in the table below. If that is not the cause, I would check the headlight dimmer switch (sounds more like it because of your dash light being out as well Hope this helps, good luck.
If your dash lights work but won’t dim and your running light won’t work and your license plate lights are out. Then there are 4 relays directly above the glove box. you can’t see them until you drop the panel. There are three 10mm bolts just in front of the latch. There are 4 relays, 3 that look the same and one that is different.
How are the tail lights and dash lights connected?
Tail lights and dash lights are connected through the tail light (and/or brake light) fuse. When the dashboard goes dark you know you are driving without tail lights. Make certain to use the exact replacement dashboard light fuse to avoid the potential of electrical failure in your vehicle’s dashboard.
Where is the fuse for the parking light relay?
This fuse will power the parking light relay that is in the same fuse micro panel. If the fuse is good, and it is a 15 amp fuse, then you will need to check the relay for the parking lights.
How are dash lights and tail lights connected?
Tail lights and dash lights are connected through the fuse. Sounds like your fuse is blown. This is a standard thing in all cars (at least before Auto Light controls) When the dash goes dark you know you are driving without tail lights.
Why does my Nissan’s dash lights go out?
The lighting circuit is connected – the dash lights went out because that’s part of the system which Nissan designed to warn you “hey buddy, you don’t have parking lights” – much easier than having to turn on your parking lights & running around the car each time. At least that was the issue I’ve seen most common & I’ve experienced a couple times.
When do the tail lights and brake lights come on?
The taillights come on when your headlights are on or your parking brake is engaged. The brake lights turn on when you apply pressure on the brakes. In most automobiles, the taillights are red while the brake lights are a brighter, more luminous red. The rear lights are controlled by the same switch as the headlights.
How do you change the headlight on a Nissan pickup?
Changing your Nissan Pickup’s headlight is a no brainer. Just make sure that you know what kind of bulbs you are going to need. Once you’re sure, just pop up the hood and locate the bulb holder and change the bulb. You may need to unfasten some latches, but overall, it’s pretty easy as 1-2-3.