Where is the radiator drain plug on a 2006 DuraMAX?
The radiator drain is on the right or passengers side of the truck, very bottom of the rad at the rear of the tank. You can reach this by going in from the right side wheel well opening. Don’t pull the drain out all the way. Just open it enough that it is draining and open the surge cap all the way.
How to drain the coolant on a Duramax LBZ 2006?
This is the Easiest way I found to drain the coolant on My 2006 Duramax LBZ Make sure you have a bigger container maybe 12 quarts hold. And to remove the coolant Cap first to release pressure .
What kind of radiator does a Duramax LB7 have?
The brushed aluminum finish and aFe POWER design painted on the front make this radiator unique as your truck.Features:100% TIG-WeldedOversized Tube & Fin CoreBillet Aluminum Inlet & Outlet The Alliant Water Pump AP63562 is the stock replacement for the faulty water pump in your 2001-2005 GM Duramax LB7/LLY.
What kind of cooling system does GM Duramax use?
This 4-row core radiator features a 2-3/4″ thick tube and fin core that delivers maximum heat dissipation and enhanced coolant flow over the factory radiator for superior cooling efficiency. The fabricated end tanks are constructed out of 1/8″ aircraft-grade aluminum plates for reliability and strength.
What kind of fan does a Duramax 6.6L have?
These cooling fans feature two 15-inch S-Blade electric fans and a Flex-a-lite Variable Speed Controller that varies the fan speed from 60-100 percent, depending on radiator temperature.
How do you remove radiator stack in Chevy Duramax?
6. while leaving the light bulbs in the assemblies, remove the plugs from the bulbs. 7. for the lower day time running and clearance lights, there is a small plastic catch on the back of the assemblies towards the outside of each one. push that together and the assemblies will come out.
Where is the Trans cooler located on a Duramax truck?
4. 2 blots the hold the trans cooler in place to the catch/ release support, and the 2 bolts that hold the A/C cooler to the top cross member. 5. the last bolt is just above the battery on the drivers side holding the little bar to the cross member.
What kind of wrench do I need to remove radiator stack?
5. a T25 TORX head (bit/screw driver/wrench whatever you choose) there are only 4 bolts/screws that you will have to remove with this. 6. you can add a good flat tip screw driver and channel locks to the list.
Why is my Duramax engine still running hot?
5. you have changed out the thermostats and have done a complete DEX-cool flush but engine is still running kind of hot.