Where is the oil drain plug on a Briggs and Stratton?
Typically, however, on vertical shaft engines, the oil drain plug is located beneath the engine block near the crankshaft. To remove the square plug, all that is required is a standard size 3/8″ ratchet and extension (no socket).
How do you change oil on a Harley Davidson Sportster?
Using a spare rag or paper towel, clean the drain plug, removing excess oil and metal shavings. There is a magnet on the end of the drain plug to capture any ferrous metal residue. Using a T27 screwdriver bit, remove the four screws holding the clutch inspection cover in place.
How does the oil drain work on a Harley Davidson?
Unlike most vehicles, the Harley Sportster Evolution Engine has an oil drain tube, not a plug. This tube is attached by a house clamp to a nipple welded to the frame. Loosen the house clamp with a Flathead Screwdriver. Do not remove the tube until you have your drain pan in position.
What’s the correct torque for a Sportster transmission?
The correct torque specification is 14 – 21 ft-lbs (168 – 252 in-lbs). Insert the nozzle of a funnel into the primary chain inspection hole. Pouring slowly, pour approximately 1 qt of oil into the transmission. As you pour, watch the clutch inspection hole. Make sure that the oil level stays below the edge of the clutch inspection hole.
Where is the oil filter on a Harley Davidson?
The oil filter is located at the front of the engine, between the frame downtube and front cylinder. Move the oil pan to the front of the bike, directly underneath the oil filter. Remove the oil filter. This may require an oil filter wrench.
How long does it take to change oil in a Harley Davidson Sportster?
Place a drain pan underneath the drain plug. Using a wrench, unscrew the transmission drain plug and remove it. Your drain plug may be 5/8″ or 3/4″ depending on the year. Allow all the oil to drain out of the transmission. It should take about five minutes.
How to remove oil from a Harley Davidson transmission?
Place a drain pan underneath the drain plug. Using a wrench, unscrew the transmission drain plug and remove it. Your drain plug may be 5/8″ or 3/4″ depending on the year. Allow all the oil to drain out of the transmission.
The oil filter is located at the front of the engine, between the frame downtube and front cylinder. Move the oil pan to the front of the bike, directly underneath the oil filter. Remove the oil filter. This may require an oil filter wrench.
The correct torque specification is 14 – 21 ft-lbs (168 – 252 in-lbs). Insert the nozzle of a funnel into the primary chain inspection hole. Pouring slowly, pour approximately 1 qt of oil into the transmission. As you pour, watch the clutch inspection hole. Make sure that the oil level stays below the edge of the clutch inspection hole.